Table of Contents
Advertisement
Lock the Gear Shaft with the Stopper Pin (22) located at
the front part of the Gear Case Cover (26).
Using a wrench, tighten the Bolt (15) over the Outside
Flange (16), counterclockwise.
9.
Place the Safety Guard (10) over the Saw Blade and tighten
in place.
10. Install the anti-kickback pawl on the Safety Guard (10) with the
pawls facing the rear of the machine.
11. Set the height by loosening its lock knob and moving it up or
down. Retighten again when set to the proper height.
12. Verify that no play exists in the carriage, and that the arm, yoke,
and bevel locks and clamps are tight.
13. Slip the Dust Guide (4) over the exhaust stem located on the
Safety Guard.
Elevating Handle (88)
Yoke Pivot Clamp Handle (88)
Safety Guard (10)
Arm Index Knob (115)
Screw Clamp (137)
ON / OFF Switch – The Switch has a built-in locking feature which
requires a key to be inserted before the saw can be turned ON.
Removing the Key and pushing the OFF button locks the saw
against unintended use. For crosscutting, press the green Switch
in, then squeeze and hold the Trigger. For rip cutting, press the
SKU 42933
For replacement parts, please call 1-800-444-3353.
Operating Controls
Switch (122) with Key (98)
Trigger
Bevel Index Knob (74)
Bevel Lock Knob (71)
Lock On Button
Safety Guard Lock Knob (5)
Anti-kickback Arm (13)
Page 7
Hide quick links:
Advertisement
Table of Contents
