Central Machinery 38123 Assembly And Operating Instructions Manual page 14

The ON/OFF Locking Switch:
1. The ON/OFF Locking Switch (22) must have the Switch Key (21) inserted before the
ON/OFF Locking Switch can be used. This feature helps prevent unauthorized use
of the Sander. (See Figure L.)
2. Insert the Switch Key (21) into the ON/OFF Locking Switch (22). (See Figure L.)
3. To turn the Sander on, place your finger under the left side of the ON/OFF Locking
Switch (22) and pull out. (See Figure L.)
4. To turn the Sander off, push in on the left side of the ON/OFF Locking Switch (22).
(See Figure K.)
5. To lock the ON/OFF Locking Switch (22) in its OFF position, push and hold the left
side of the Switch while pulling out the Switch Key (21). Always lock the Switch in
its OFF position when the Sander is not in use. (See Figure L.)
INSERT
SWITCH KEY (21)
FIGURE L
Sanding Methods: Surface Sanding On The Sanding Belt:
FIGURE M
WORKTABLE (35)
SKU 38123 For technical questions, please call 1-800-444-3353.
PULL OUT TO TURN
LOCKING SWITCH ON
(22)
PUSH IN TO TURN
LOCKING SWITCH OFF
(22)
BACKSTOP (9)
SURFACE SANDING
ON SANDING BELT (10)
Page 14