Summary of Contents for One Stop Gardens BACKPACK SPRAYER 94573
Page 1
Harbor Freight Tools. Diagrams within this manual may not be drawn proportionally. Due to continuing improvements, actual product may differ slightly from the product described herein. Tools required for assembly and service may not be included.
SAVE ThIS MAnuAL Keep this manual for the safety warnings and precautions, assembly, operating, inspection, maintenance and cleaning procedures. Write the product’s serial number in the back of the manual near the assembly diagram (or month and year of purchase if product has no number).
SPECIFIC SAFETY RuLES Maintain labels and nameplates on the Sprayer. These carry important information. If unreadable or missing, contact Harbor Freight Tools for a replacement. use the right product for the job. There are certain applications for which this product was designed. Do not use...
Page 4
Always follow all chemical label precautions and local EPA regulations when using liquid chemicals. Do not touch harmful chemicals. After use, clean the Sprayer thoroughly with agents recommended by the chemical manufacturer. never point the nozzle of the Spray Gun Assembly at yourself, other people, pets and animals, or property.
the tool if the power cord or plug is damaged. If damaged, have it repaired by a service facility before use. If the plug will not fit the outlet, have a proper outlet installed by a qualified electrician. double Insulated Tools: Tools with Two Prong Plugs Outlets for 2-Prong Plug Tools marked “Double Insulated”...
ASSEMBLY And OPERATInG InSTRuCTIOnS CAuTIOn! Wear eye, breathing, and skin protection. Wear ANSI-approved safety impact goggles, a NIOSH-approved respirator, latex gloves, and proper safety clothing when using this product. nozzle Selection And Assembly: The Sprayer is equipped with the following Nozzle types: FIGuRE F a.
Page 8
To Fill The Tank: TAnK CAP (41) TAnK FILTER (42) FIGuRE K Prior to filling the Tank (64) of the Sprayer with liquid, remove the Tank Cap (41) and check to make sure the Tank Filter (42) is clear of dirt and debris. If necessary, remove the Filter and thoroughly clean.
InSPECTIOn, MAInTEnAnCE, And CLEAnInG CAuTIOn! Make sure the Power Switch (58) is in its “OFF” position and unplugged from its Charger (63). Then, de-pressurize the system before performing any inspection, maintenance, or cleaning of the Sprayer. Before each use, inspect the general condition of the Sprayer.
nOTE: Some parts are listed and shown for illustration purposes only, and are not available individually as replacement parts. SKU 94573 For technical questions, please call 1-800-444-3353. ASSEMBLY dIAGRAM 57, 56 28, 27, 26 11 12 Rev 10d Page 11...