Page 1
. All rights reserved. No portion of this manual or any artwork contained herein may be reproduced in any shape or form without the express written consent of Harbor Freight Tools. For technical questions and replacement parts, please call 1-800-444-3353...
Protective, electrically non-conductive clothes and non-skid footwear are recommended when working. Wear restrictive hair covering to contain long hair. Use eye and breathing protection. Always wear ANSI approved impact safety goggles. Wear an ANSI approved respirator when spraying. SKU 02471 Specifications 1.45 Gallons 1/4” NPS (Male) 50 - 70 PSI 10”...
Page 3
22. Do not operate Spray Gun near open flames, pilot lights, heaters, or any other heat source. Make sure you have adequate ventilation. Most solvents and paints are extremely flammable, especially when sprayed. Never smoke cigarettes in the same room you are working in. SKU 02471 Page 3...
Page 4
(California Health & Safety Code 25249.5, et seq. ) When unpacking, check to make sure the parts listed on page 8 are included. If any parts are missing or broken, please call Harbor Freight Tools at the number on the cover of this manual as soon as possible.
Page 5
For best service, you should incorporate an air dryer, a regulator, and an inline air filter, as shown above. We recommend an air dryer to send moisture-free air to the Spray Gun. All are available at Harbor Freight Tools. 1. You will need to prepare a 1/4” air connector (sold separately) to connect to the Air Inlet (#13).
Correct angle. Problem 5: Air mixes with paint. Cause: Worn Assembly Set Solution: Have a qualified technician replace the SKU 02471 TroubleShooting Nozzles (#2a, #2b, #2c). Nozzles (#2a, #2b, #2c) center holes. #2c), soak in solvent, and wipe clean. and clean.
Regulator Guide (#8) and the Needle Shaft (#9). Do not force any parts or they will break. Wipe the entire Body (#3) clean with a lint free cloth. Note: Always dispose of paints and solvents properly. Consult the local hazardous waste authority for proper disposal procedures and sites. SKU 02471 Page 7...
REPAIRS TO THE ORIGINAL PRODUCT OR REPLACEMENT PARTS THERETO, OR ARISING OUT OF HIS OR HER INSTALLATION OF REPLACEMENT PARTS THERETO. NOTE: Some parts are listed and shown for illustration purposes only and are not available individually as replacement parts. SKU 02471 Parts List Description Retaining Ring Nozzle (.177”)