SPECIFICATION
W
WASH
WATER SELECTOR
D
H
Power source
ON SPECIFICATION LABEL
Water Level
H : 67 , M : 58 , L : 50 , S : 43
Water Pressure
Less than 100kPa (1kgf/cm
2
)
Dimension
850
X
530
X
1017 mm. (W D
X
X
H)
For Non-Pump Model
40.5 kg
Weight
For Pump Model
41.1 kg
How to read the manufactured month and year from the label stuck on the
back of the product.
EX) 4 0 1 T W 0 0 0 0 1
Serial No.
Product code
Month
Year (The last digit to year)
Main service part list : Refer to below listed part name when you need
service call.
Part name
Remark
- WASH MOTOR
105 W (Output)
- SPIN MOTOR
105 W (Output)
- S.D. BASKET
PLASTIC
- CYCLE TIMER ASSEMBLY
- CAPACITOR
- GEAR CASE ASSEMBLY
P/No. : 3828EY3049A
8
CAUTION
CAUTION
Installation Area
Heat
Avoid electric heater, candle light,
Avoid area exposed to snow,
cigarette light, bug smoker,
rain, or where humidity
etc. near the machine.
is high. It may cause
It may ignite or
electric shock.
deform
plastic part.
Hot water
Switch Area
Avoid watering on the
Avoid using hot water
switch area.
over 50°C. It may
It may cause
deform plastic parts
electric shock
or cause malfunction.
or fire.
Volatile Material
In Operation
Do not use volatile material such as
Do not insert the hand inside the spin
Benzene, Gasoline, bug killer.
dryer basket while the machine is in
Do not leave strong alkaline substance
operation (Do not let children climb on
such as bleach inside
the machine or climb into
the tub. Damage on
the tub. Injury may occur.)
plastic surface and
rubber parts may occur.
Installation
Power Cord
Install the washing machine on
If the power supply cord is damaged, it
must only be replaced by the
a horizontal support.
manufacture or its service agent or a
Otherwise,
similarly qualified person in order to
it may cause
avoid a hazard.
vibration and noise.
Electric Outlet
Avoid connecting several electric
devices to single outlet. It may cause
fire.
Be sure to earth the washer to prevent electric shock. To reduce
the risk of electric shock, do not install the washer in humid spaces.
Connecting the drain hose
Push the clamp toward the body of the washing machine as shown in
the figure.
For Non-Pump Model
Be sure to reroute the hose so that it is not kinked; kinks or sharp
bending in the hose will prevent proper drainage.
Make sure water is draineded smoothly by placing a base under the
machine or by applying other appropriate mean.
L
For Pump Model
L <= 1 m.
2