÷
u
m
READ BEFORE
iNSTALLiNG
UNIT
Compact
ni Window
Mounting
Your ah"conditioner
is designed
to install in skmdard
double llm_g windows
with opening
widths of 22 to 36
inches (559 mm to 914 ram) (FIG.
l)
Lower sash must open sufficiently 1o allow a clear velltical
opeuing of 14-1/2 inches (368 rnm). Side loovers and the
rear of the AC most have clear air space to allow
enoogh airflow throogh the condensel; for heat removal.
The rear of' the onit most be ootdoors, not inside a
boilding or garage.
NOTE:
SAVE CARTON aud these INSTALLA-
TION INSTRUCTIONS
tbr furore reference. The caJlon is
the best way to store unit during winter, or when not hi use,
When handling
unit, be careful to avoid cuts
from sharp metal edges and aluminum
fins on
front and rear coils.
Befbre installing
the unit, the Left-Hand
Louver
must be assembled
to the unit:
A. Carefully remove power supply
cord flx)m air discharge area
(Fig. A).
B. Carefully remove dte Left-Hand
Louver Assembly from the
discharge area, and theu remove
it fl:om the plastic bag(Fig. B).
C. With care, pry apaJl tile auger
wheel shaft fl:om tile horizontal
k)uver casing, as shown hi Fig.
C,D&E.
Some assemNy
is required.
Please read these instructions
÷
Mounting
Hardware
3/4 'screws
lock frame
sash lock
TOOLS
NEEDED:
*
Drill (If pilot hales are needed)
Qty.
7
D. Now locate tile auger wheel
shaft into tile vertical ceuter
post (Fig. F).
E. Clip the oilier end hllo tile
locating slot.
E Now place the horizontal louver
casing onto the auger wheel
shaft, and snap in place (Fig.
G).
G,
Check tile operation
by moving
tile horizontal
louver up and
down, and theu turn file auger wheel so file vertical
kmvers
rotate.
SZOOO357(En)
1
,
10/21/2004,
10:42 AM