Page 1
Installation instructions For Heavy Duty {FAS Mode|s) Median {FAM Mode|s) Air Conditioners Please read ALL instructions before installing.Two people are recmnmended to install this product.If a new electrical outlet is required,have the outlet installed by a qualified electrician before installing unit.
Page 2
CHECK FOR ANYTHING THAT COULD BLOCK Too|s Required AIRFLOW - check area outside of window for things such as shrubs, trees, or awnings. Inside, be sure a large flat blade screwdriver furniture, &apes, or blinds will not stop proper air flow. tape measure adjustable wrench...
Page 3
Window Mounti install Top Angle Remove Chassis and Side Bracket 1. Pull dewn fiont panel mad remove tilter. (See FIG. 1). Attach foam gasket to top angle above holes as 2. Lift fiont upwards and place to one side. shown in FIG. 6. FIG.
Page 4
|nstall Support 3. Insert top and bottom legs of window filler panel frame Bracket into channel in the to angle and bottom rail. Do both sides. Hold each support bracket flush against outside of sill, 4. Insert washer head locking screws (2) into holes in and tight to bottom of cabinet as shown below.
Page 5
install Chassis into Extend Window Filler Cabinet and |nstall Panels Front to Unit 1, Carefully raise window to expose filler panel locking 1. Lift air conditioner and carefully slide into cabinet screws. Loosen screws so filler panels slide easily. leaving 6" protruding. 2, _DO not push on controls OR finned coils, 3.
Thru-The-Wall Installation NOTE: Consult local building codes prior to installation, Carefully measure and cut an opening with the following or a qualified carpenter. dimensions depending on your model. See FIGS. land 2. WIDTH "X" - inside model width plus twice the thickness Select Wall Location...
Page 7
NOTE: If wall thickness is 8-1/2" or more, add aluminum flashing over bottom of flame opening to assure no water FIG.2 can enter area between inner and outer wall. 1"LONG WOOD SCREW Refer to Step 4 of Window Mounting for assembly of support brackets.A wooden strip nailed to the outside ALUMINUM FLASHING...
OPTIONAL:Caulking a udinstallation o f trimoninterior wallmay bedone. Youcanbuywood fromyourlocal l umber orhardware s upply. Ontheoutside, caulk openings around top and sides of cabinet, andallsides o f wood sleeve t otheopening. NOTE: See Step 7,Item3of Window Mounting Instructions forbottom railseal location. Masonry Construction 1.
This manual is also suitable for:
Cae15esr2Cahe18er1Cahe25er1Fam156r1a1Fam186r2a2Fam18er2a1...
Show all
Fas256r2a1Fam186r2a1Fas296r2a1Fas25er2a1Fas seriesFsm series