Advertisement
Quick Links
|nstal|ation
|nstruc i
READ BEFORE iNSTALLiNG UNiT
OPPSK Window Mounting
Your air conditioner is designed to install in standard
double hung windows with opening widths of 23 to 36
inches (584 mm to 914 mm) (FIG. l)
Lower sash must open sufficiently to allow a clear vertical
opening of 13 inches (330mm). Side louvers and the
rear of the AC must have clear air space to allow
enough airflow through the condenser, for heat removal.
The rear of the unit must be outdoors, not inside a
building or garage.
Fig. 1
NOTE:
SAVE CARTON and these INSTALLATION
INSTRUCTIONS for future reference. The carton is the
best way to store unit during winter, or when not in use.
Some assembly is required. Please read these instructions
carefully.
f
Mounting
Hardware
3/4"screws
lock flame
sash lock
Qty.
7
TOOLS
NEEDED:
- Phillips ScrewDriver
• Drill(Ifpilotholesareneeded)
NOTE: DO NOT USE ANY SCREWS OTHER THAN
THOSE SPECIFIED HERE
When handling unit, be careful to avoid cuts
from sharp metal edges and aluminum fins on
front and rear coils.
Before installing unit, the top rail must be
assembled
on the unit.
Top
Rail Hardware
Qty.
3/8" Screw
4
Top Rail
1
Top
TOOL
NEEDED:
,
Phillips Screwdriver
A.
B°
C.
D.
Remove the air
conditioner from the
carton and place on a
flat surface.
Remove top rai! from
the bottom of the
packaging material as
shown in Fig. A
Align the hole in the
mp rail with those in
the top of the unit as
shown in Fig. B
Secure the top rail to
the unit with the 3/8"
Screws as shown in
Fig. C
ging
Fig. A
NOTE:
FOR
SAFETY
REASONS,
ALL
FOUR
(4) SCREWS
MUST
BE SECURELY
FASTENED.
P/N 2020211A0472
Advertisement
Related Manuals for Crosley CAE5MC
Summary of Contents for Crosley CAE5MC
- Page 1 |nstal|ation |nstruc i READ BEFORE iNSTALLiNG UNiT OPPSK Window Mounting Your air conditioner is designed to install in standard double hung windows with opening widths of 23 to 36 inches (584 mm to 914 mm) (FIG. l) When handling unit, be careful to avoid cuts Lower sash must open sufficiently to allow a clear vertical from sharp metal edges and aluminum fins on opening of 13 inches (330mm).
- Page 2 How to Install NOTE: Top Rail and Sliding Panels at each side are offset to provide the proper pitch to the rear of (5/16"). This is necessary for proper condensed water utilization and drainage. If you are not using the Side Panels for any reason, this pitch to the rear must be maintained! Place unit on floor, a bench or a table.
- Page 3 Place the frame lock between the frame Cut foam seal and insert in the space extensions the window sill as shown between the upper lower sashes (FIG. 1 3). (Fig. 8). Drive 3/4" (19 ram) locking screws through the frame lock and into the sill...