GE JP655 Installation Instructions Manual
36"
Hide thumbs
Also See for JP655:
- Owner's manual (36 pages) ,
- Installation instructions manual (17 pages) ,
- Planning manual (4 pages)
Table of Contents
Advertisement
Quick Links
I Iinstallation
136" Electric C ooktop
nstructlons
=_
If you have questions,
call 800.GE.CARES
or visit our website
at:
www.G EAp plia nces.co m"
I
BEFORE YOU BEGIN
Read these
instructions
completely
and carefully.
• IMPORTANT - Save t hese
instructions
for local
inspector's
use.
• IMPORTANT - Observe all
governing
codes
and ordinances.
• Note to Installer
- Be sure to leave these
instructions
with
the Consumer.
• Note to Consumer
- Keep these
instructions
for future
reference.
• Product
failure
due to improper
installation
is not covered
under
the Warranty.
-&WARNING
-
This appliance
must
be properly
grounded.
• ATTENTION
INSTALLER -
ALL COOKTOPS
MUST
BE HARD WIRED
(DIRECT
WIRED)
INTO AN APPROVED
JUNCTION
BOX. A "PLUG
AND
RECEPTACLE"
IS NOT PERMITTED
ON
THESE PRODUCTS.
• Proper installation
is the responsibility
of the installer
and product
failure due to
improper
installation
is NOT covered
under
warranty.
MATERIALS
YOU WILL NEED
Junction Box
Wire Nuts
TOOLS YOU WILL NEED
%
Pencil
Saber
Saw
Phillips
Head
Screwdriver
Ruler or Straightedge
1/8" Drill Bit & Electric
or Hand Drill
Safety
Glasses
PARTS INCLUDED
4 Screws
Foam Tape
2 Hold Down
Brackets
31-10606-1
(05-06 JR)
1
Advertisement
Table of Contents
Related Manuals for GE JP655
Summary of Contents for GE JP655
- Page 1 136" Electric C ooktop nstructlons I Iinstallation www.G EAp plia nces.co m" If you have questions, call 800.GE.CARES or visit our website BEFORE YOU BEGIN MATERIALS YOU WILL NEED Read these instructions completely and carefully. • IMPORTANT - Save t hese...
-
Page 2: Important Safety Instructions
Installation Instructions IMPORTANT SAFETY INSTRUCTIONS FOR YOUR SAFETY ELECTRICAL REQUIREMENTS * For Personal Safety, remove house fuse This appliance must be supplied with or open circuit breaker before beginning proper voltage and frequency, and connected installation. Failure to do so could result to an individual, properly... -
Page 3: Pre-Installation
Installation Instructions PRE-INSTALLATION CHECKLIST - WARNING Remove Installation Instructions from The electrical power literature pack and read them carefully to the cooktop supply line must be shut off before you begin. while connections are being made. Failure to do so could result in serious injury or death. -
Page 4: Preparing The Opening
Order kit JXFLM2XX from minimum clearance of 24" is required your GE Dealer. the underside of the cabinets above cooktop must be protected with not less than 1/4" insulating millboard covered with... -
Page 5: Installing The Cooktop
Installation instructions INSTALLING THE COOKTOP _-I INSTALLING ATTACH FOAM TAPE JUNCTION Apply the foam tape around the outer edge of the glass. Do not overlap the foam tape. Install an approved junction box where it will be easily reached through the front of the Bottom... -
Page 6: Insert Cooktop Into Cutout
Installation Instructions INSTALLING THE COOKTOP (CONT.) INSERT COOKTOP ATTACH HOLD DOWN INTO CUTOUT BRACKETS TO CABINET Insert the cooktop centered into the cutout Open the cabinet door and screw the Hold Down Brackets to the cabinet sides with opening. Make sure the front edge of the countertop is parallel... - Page 7 Installation Instructions INSTALLATION--ELECTRICAL CONNECTIONS When making the wire connections, Once the connections are made, secure the entire length of conduit provided. wires together using wire nuts. The conduit must not be shortened. With the cooktop in place, open the front of the cabinet door.
-
Page 8: Operation Checklist
Installation Instructions CHECKLISTS OPERATION CHECKLIST -IPRE-TEST CHECKLIST Remove all items from the top Remove all protective film, if present, and any stickers. of the cooktop surface. Check to be sure that all wiring is secure Turn on the power to the cooktop. and not pinched or in contact with...