Kenmore 630.1390 Installation Manual
Hide thumbs
Also See for 630.1390:
- Use & care manual (23 pages) ,
- Use & care manual (22 pages) ,
- Use & care manual (63 pages)
Advertisement
Quick Links
Download this manual
See also:
Use and Care Manual
Installation Guide
Instrucciones de Instalaci6n
instructions dlnstallation
English / Espafiol/Frangais
Models/Modelos/Mod_les:
630.1390% 630.1 391 _
I<enmore Elite
@
COO
w _sn6_o
/_ G CO_J@J_'
Ge
......
Ge
P/N
9000543976
Rev. A
Sears Brands
Management
Corporation
Haft:man
Estates,
IL 60179
U.S.A.
www.kenmore.com
www.sears.com
Sears Canada
Inc.
Toronto,
Ontarlot
Canada
M5B 2B8
www.sears.ca
Advertisement
Related Manuals for Kenmore 630.1390
Summary of Contents for Kenmore 630.1390
- Page 1 Installation Guide Instrucciones de Instalaci6n instructions dlnstallation English / Espafiol/Frangais 630.1390% 630.1 391 _ Models/Modelos/Mod_les: I<enmore Elite ..w _sn6_o /_ G CO_J@J_' 9000543976 Rev. A Sears Brands Management Corporation Haft:man Estates, IL 60179 U.S.A. www.kenmore.com www.sears.com Sears Canada Inc.
-
Page 2: Warnings And Cautions
Dishwasher Safety ............Water supply requirements ............Installation Requirements ..........Electrical requirements ..............Materials needed ..............Installation Instructions ..........Tools needed ................. Materials supplied ............... Pre-install checklist ............... Drain requirements ..............To avoid possible injury or property damage, OBSERVE ALL Make sure electrical work is properly installed. - Page 3 Read theseinstallatlon instructions c ompletely This dishwasher is designed to be enclosed on the top and a nd follow both sides by cabinetry. them carefully. They will save you time and effort and help NEW INSTALLATION - If the dishwasher isa new installation, to ensure safety and optimum dishwasher...
- Page 4 Hammer Hole Saw Safety Glasses Adjustable Wrench Pliers Needle Nose Pliers Work C_loves Screwdrivers Level Drill Measure Tape Wire Strippers Mounting Bracket Screws Spring Clamp Screw Clamp Junction Box Screw Toe Panel Screws Drain Hose Leg Leveler Screws...
- Page 5 IMPORTANT! Before you begin, you must read the safety instructions! Avoid Scalding or Electrical Shock Hazard! PRE-INSTALL CHECKLIST Make sure the water supply and electrical supply are shut [] Unpack unit. Retain packing material until successful off before installation or service. installation is complete.
- Page 6 Note: Plumbing installations will vary - refer to local codes. Drain hose included is 92" (234 cm) and can be extended a maximum of 150" (381 cm). Ensure a portion of the drain hose is raised at least 20" (51 cm) above the floor.
- Page 7 STEP | Enclosure Preparation NOTE: This dishwasher is designed to be enclosed on the top and both sides by standard residential kitchen cabinetry. Select a location as close to the sink as possible far easy access to water supply and drain lines. Far proper dishwasher operation...
- Page 8 Electrlcal Supply Ensure that the dishwasher electrical installation is in compliance with all national and local electrical codes and ordinances. The dishwasher is designed for an electrical supply of 120V, 60 Hz, AC, connected to a dishwasher-dedicated, properly grounded electrical circuit with a fuse or breaker rated 15 amps.
- Page 9 STEP 4 Removing the junction box cover While unit is still in position as shown in the figure to the left, remove the iunction box cover and set it aside. You will need it later. STEP 5 Removing the strain relief plate Once you remove the iunction box cover, remove the strain relief plate...
- Page 10 STEP6 Attaching the hot water ilne NOTE: The 90 ° elbow fitting is not supplied with the dishwasher and must be purchased separately (see "Materials Needed" section). STEP 1 To prevent leaks, wrap the dishwasher elbow with plumbing tape firmly in a clockwise direction twice.
- Page 11 STEP 7 Attaching the mounting brackets NOTE: Before installing the mounting brackets, please FOR WOODEN UNDERCOUNTER decide which method of securing the dishwasher appropriate, i.e side mount or top mount. Top mount is used countertops made of wood or other materials that can be drilled easily.
- Page 12 STEP9 Moving dishwasher into the cabinet iMPORTANT: Do not atlow teg teveters to scratch or mark floor. Ptace hands where pictured to push into pMace. As you slide the unit it, guide the water line and drain hose toward the sink, and electric line beneath the unit.
- Page 13 STEP 11 Electrlcal Connection Pass wires through strain relief and plate. Leave 3 to 4 inches of insulated wire extending through the strain relief plate. Tighten clamp around wires, oriented as shown. Bending the electricai cable as shown will ease installation of the strain relief plate.
- Page 14 Note: Do not loosen or remove termlnal screws! Damage may occur. Bend the wires so the exposed leads can reach the appropriate contacts. Insert the black (hot) wire into the left opening on the terminal strip marked %', the white (neutral) wire in the middle opening...
- Page 15 STEP 12 Restoring the junction box cover Replace iunction box cover. Make sure the cover is seated behind the front lip of the strain relief plate. Attach cover with the screw (part F) from the installation kit. STEP 13 NOTE: if the dishwasher is nat leve!, it may nat operate properly...
- Page 16 STEP]4 Attaching the mounting brackets Insert screws (part A) through pre-positioned mounting brackets and attach unit to enclosure (pre-drilling of holes recommended). STEP15 Drain Hose Connection Route drain hose to household plumbing. Note: Plumbing installations will vary - refer to local codes. Always include a Loop in the Drain Hose for proper function...
- Page 17 Attach drain hose (part D) to plumbing with screw clamp (part C) and tighten. Do nat make any connections to the air vent hose. Do nat cut drain hose. Coil excess drain hase safely inside cabinet behind unit. NOTE: When connecting drain hose to disposal, make sure that disposal...
- Page 18 STEP17 Installlng the toe panel Attach the metal toe panel with screws (Part E) so it is flush with the floor. Your installation is now complete. STEP 18 Check operation Turn the fuse back on. Read the Use and Care Manual that came with your dishwasher.