Page 2
If the unit is with our operating instructions. Your new Whistler power inverter allows you to run most AC appliances right from your car, boat or RV. They’re great for weekend use and life on the road. They’re also great for...
AC output is called “modified sine wave”. See “Technical Operating Principles” section for more information. Depending on the model and its rated capacity, WHISTLER inverters draw power either from standard 12 volt automobile and marine batteries or from portable high power 12 volt sources.
WHISTLER inverter and keep the manual on file for future reference. Notes: Your WHISTLER inverter is designed to operate from a 12 volt power source only. Never attempt to connect your Whistler inverter to any other power source, including any AC power source.
Page 9 INVERTER BASICS Don’t Push It. Although your WHISTLER inverter has the capacity to provide power output (excess current) equal to approximately two times its rated wattage capacity for a very brief period, it is designed to operate equipment and appliances with start up load wattage ratings no higher than its own maximum continuous wattage rating.
Make certain the cause permanent damage to the inverter. caused by reverse polarity is not covered under the WHISTLER warranty. • Making the connection between the Positive terminals may cause a spark as a result of current flowing to the capacitors in the inverter.
Page 7
pro200-400w.qxp 4/30/2010 9:07 AM Page 13 OPERATION • Pro-400W watt model - If the supplied cables are too short to allow for placement of the inverter in a desired location, the inverter may be connected to the power source using a #8 wire, up to 12’. Use #4 wire for longer lengths.
pro200-400w.qxp 4/30/2010 9:07 AM Page 15 OPERATION does blow, turn off and disconnect the appliance or equipment from the inverter immediately, repair the related problem and replace the fuse(s). The internal fuses are replaceable, however only electronically knowledgeable people should attempt fuse replacement. Note: •...
Do not place the inverter in areas such as battery compartments. Where fumes or gases may accumulate. In Review. • Never attempt to operate your WHISTLER inverter from any power source other than a 12 volt battery or group of batteries that total 12 volts.
Page 10
Consequently, these meters will not read the RMS modified sine wave voltage correctly and, when measuring your WHISTLER inverter output, the meters will read about 20 to 30 volts too low. To accurately measure the output voltage of your inverter, use a true RMS reading voltmeter such as a Fluke 87, Fluke 8060A, Beckman 4410, Triplett 4200 or any multimeter identified as "True RMS."...
pro200-400w.qxp 4/30/2010 9:07 AM Page 21 OPERATION SUMMARY • This inverter is designed to be connected to the power source with the supplied cables or with #8 wire up to 12’ Use #4 wire for longer length. supplied cables do not attempt to modify or lengthen them.
pro200-400w.qxp 4/30/2010 9:07 AM Page 23 TROUBLESHOOTING Please visit our Inverter FAQ page on our website whistlergroup (www. .com), for more troubleshooting information and FYI topics. PROBLEM: TV Interference Problem Solution Electrical interference from Add a Ferrite data line filter inverter.
TV is compatible with a modified sine wave. A larger inverter may be required. SPECIFICATIONS Pro-200W WATT INVERTER SPECIFICATIONS Maximum Continuous Power ...200 Watts Maximum Surge Capability (Peak Power) 400 Watts No Load Current Draw...<0.6 A Waveform ...Modified Sine Wave Operating Input Voltage Range.11–...
Page 14
All express or implied warranties for this product are limited to two years. Whistler is not liable for damages arising from the use, misuse, or operation of this product.
Page 15
• The unit has been abused, modified, installed improperly, or had its housing removed. The minimum out of warranty service fee for your Whistler 200 watt inverter is $15.00 (U.S.) and the 400 watt inverter is $20.00 (U.S.). If you require out of warranty service, please return your unit as outlined in the section “Service...