Advertisement
Quick Links
READ BEFORE INSTALLING
UNIT
For Low Profile Window Air Conditioner
To avoid risk of personal injury, property damage, or product damage due to the weight of this device and sharp
edges that may be exposed:
Air conditioners covered in this manual pose an excessive weight hazard. Two or more people are needed to
move and install the unit. To prevent injury or strain, use proper lifting and carrying techniques when moving unit.
Carefully inspect location where air conditioner will be installed. Be sure it will support the weight of the unit over
an extended period of time.
Handle air conditioner with care. Wear protective gloves whenever lifting or carrying the unit. AVOID the sharp
metal fins of front and rear coils.
Make sure air conditioner does not fall during installation.
® SAVE CARTON and these INSTALLATION INSTRUCTIONS for future reference. The carton is the best way to
store unit during winter, or when not in use.
o DO NOT USE ANY SCREWS OTHER THAN THOSE SPECIFIED IN THESE INSTRUCTIONS.
Tools
Required
® SCREWDRIVER
(Standard and Phillips and Flathead)
o RULER
• KNIFE
• HAMMER
• PENCIL
•
LEVEL
Hardware ( in plastic bag)
SHORT LEVELING BOLT
1
SUPPORT BRACKET
1
LONG LEVELING BOLT
1
1/2°'SCREW
Qty.
Hardware (in plastic bag)
SASH LOCK
WEATHER SEALS
(6"X3/4"X1/12")
WINDOW SASH SEAL
FOAM STRIP
Qty.
5
2020211A1455
Advertisement
Related Manuals for Kenmore 25370062011
Summary of Contents for Kenmore 25370062011
- Page 1 READ BEFORE INSTALLING UNIT For Low Profile Window Air Conditioner To avoid risk of personal injury, property damage, or product damage due to the weight of this device and sharp edges that may be exposed: Air conditioners covered in this manual pose an excessive weight hazard. Two or more people are needed to move and install the unit.
- Page 2 How to install the unit 1. To prevent vibration and noise, make sure the unit is installed securely and firmly. 2. Install the unit a little slanted so the back is slightly lower than the front (about 1/4"). This will force condensed water to flow to the outside.
- Page 3 CuttheFOAM STRIP tofit theunderside o fthewindow sash.Openthewindow, p eeloffthebackandattach theFOAM STRIP asshown in FIG.5 Markcenter l inewithpencil o nthecenteroftheinnersill,asshown in FIG.6 FiG. 6 FiG. 5 FOAM STRIP CENTER LINE INNER SILL Install support bracket on window sill. See FIG.7. Install leveling bolt up through bottom side of support bracket. You can choose a short bolt or a long one according to window type.
- Page 4 SECURE THE CURTAIN FRAMES: Expand the filler panels and secure them using 4 screws as shown in FIG.10. When filler panels opens or closes, you may feel a slight resistance. This is normal. WINDOW SASH SEALAND WINDOW LOCK: Cut the window sash seal to the window width. Stuff the window sash seal between the glass and the window to prevent air and insect from getting into the room, as shown in FIG.10.
-
Page 5: Removal From Window
REMOVAL FROM WINDOW: Turn off and unplug the air conditioner. Unscrew the side screws that you installed in step 6 and 7. Close the filler panels and remove window sash seal and sash lock from windows. Keep a firm grip on the air conditoner as your sash. Lift the air conditioner from the window.