Take Single Wavelength Measurements (Single Reading); Take Single Wavelength Measurements (Continuous Readings); Set The Dilution Factor - Hach DR 5000 User Manual

5.4.4.1 Take single wavelength measurements (single reading)

5.4.4.2 Take single wavelength measurements (continuous readings)

5.4.5 Set the dilution factor

1. Insert the blank cuvette into the cuvette/sample cell holder.
Press Zero.
Note: The Read key is only active after the zero measurement has
been carried out.
2. Insert the sample cuvette into the cuvette/sample cell holder.
Press Read.
Note: For data storage, see
1. Insert the blank cuvette into the cuvette/sample cell holder.
Press Zero.
Note: In the reading mode "Continuous" only the Zero key is shown to
start the reading. The reading sequence is started automatically.
2. Insert the sample cuvette into the cuvette/sample cell holder.
3. Press Options and then the Store icon to store the displayed
data in the Data Log.
Note: For data storage, see
The Dilution Factor function is used to calculate the original
concentration of a sample that has been diluted by a known ratio.
For example, dilution factor can bring the analyzed concentration
within the test range.
1. Press Options>More...>Dilution Factor.
The number entered at the dilution factor prompt will be
multiplied by the result to compensate for the adjustment.
For example, if the sample has been diluted by a factor of 2,
enter 2. The default setting of the dilution factor is turned off.
2. Press OK to confirm.
Standard Operations
section 5.3.2 on page 38.
section 5.3.2 on page 38.
45