SCCG50 & SCCP50 Installation and User's Manual Introduction: This ice machine is the result of Scotsman’s decades of experience as an industry leader in the design and manufacture of both commercial and residential ice machines. This manual includes the information needed to install, start up and maintain the ice machine.
Door Panels: Finished door panels are available limits. Use outside of the listed limitations is misuse from Scotsman for attachment to the machine, or a and will void the warranty. custom panel can be made. The panel kits are:...
They meet or exceed the Control Panel standards of agencies like U.L. Scotsman assumes no liability or responsibility of any kind for products manufactured by Scotsman that have been altered in any way, including the use of any parts and/or other components not specifically approved by Scotsman.
• impurities or minerals will have to be regularly be connected to cold, potable water • dissolved by an acid cleaning, using Scotsman Ice be connected to a drain Machine Scale Remover. Directions for this may be • be connected to the proper power supply found in the section under cleaning.
See instructions in information packet to create and attach a custom panel: Door Panel Attachment To attach a Scotsman supplied panel: Note: If door swing is to be changed, it must be done before panel is attached. The panel will be held on by 6 sheet metal screws and 2 machine screws.
SCCG50 & SCCP50 Installation and User's Manual Door Panel Attachment Use Upper Hole at the Scotsman Door Panel Gasket Machine Screw Hole Plug Use Lower Hole at the Bottom Cover June 2008 Page 7...
SCCG50 & SCCP50 Installation and User's Manual Door swing change The door can be attached to open with hinges on 8. Replace the bracket with the one supplied the left or right using new hinge brackets shipped loose with the machine. Secure it using the loose in the ice bin.
SCCG50 & SCCP50 Installation and User's Manual Installation: Water & Drain The recommended water supply tubing is ¼ inch 3. Install a compression fitting on the tubing and OD copper. Stainless steel flex or reinforced PCV connect to the inlet of the solenoid.
SCCG50 & SCCP50 Installation and User's Manual Gravity Drain Caution: Restrictions in the drain system to the 4. Connect a straight 5/8” barbed connector to the machine will cause water to back up into the ice drain hose, securing with the clamp removed in storage bin and melt the ice.
SCCG50 & SCCP50 Installation and User's Manual Electrical The ice machine is supplied with a power cord. Do Installation check list: not remove the grounding pin from the cord’s plug. 1. Has the unit been connected to the proper Do not use extension cords. Follow all codes.
SCCG50 & SCCP50 Installation and User's Manual No special instructions are needed for use. Just take as much ice as you need, the machine will replace it. A scoop is provided, and it can be stored in the machine using the loop of tubing on the right side as a holder.
SCCG50 & SCCP50 Installation and User's Manual How to clean the condenser and winterize. Condenser cleaning Winterizing The condenser is like the radiator on a car, it has 1. Clean the ice making system. fins and tubes that can become clogged with dirt and lint.
The ice scoop should be washed regularly, wash it just like any other food container. 4. Pour 4 ounces of Scotsman Ice Machine Scale Remover (available from a local Scotsman What to do before calling for service Distributor or Dealer) into the ice machine reservoir.
Page 16
SCOTSMAN ICE SYSTEMS 775 Corporate Woods Parkway, Vernon Hills, IL 60061 800-533-6006 www.scotsman-ice.com 17-3191-02...