Horizon Fitness Elite T5000 Owner's Manual

Horizon Fitness Elite T5000 Owner's Manual

Hide thumbs Also See for Elite T5000:

Advertisement

Elite T5000
TREADMILL OWNER'S MANUAL
Read the TREADMILL gUIDE before using this OWNER'S MANUAL.

Advertisement

Table of Contents
loading

Summary of Contents for Horizon Fitness Elite T5000

  • Page 1 Elite T5000 TREADMILL OWNER’S MANUAL Read the TREADMILL gUIDE before using this OWNER’S MANUAL.
  • Page 3 ASSEMBLY WARNING There are several areas during the assembly process that special attention must be paid. It is very important to follow the assembly instructions correctly and to make sure all parts are firmly tightened. If the assembly instructions are not followed correctly, the treadmill could have frame parts that are not tightened and will seem loose and may cause irritating noises.
  • Page 4 SPEAKERS USB PORT AND AUDIO IN JACK WATER BOTTLE HOLDER Elite T5000 CONSOLE GRIP PULSE HANDRAILS SAFETY KEY PLACEMENT IN-REACH CONTROLS CONSOLE MAST ON/OFF SWITCH MOTOR COVER CIRCUIT BREAKER DROP-DOWN HANDLEBAR POWER CORD TRANSPORT WHEEL ROLLER END CAP RUNNING BELT / RUNNING DECK SIDE RAIL REAR ROLLER TENSION/ADJUSTMENT BOLTS...
  • Page 5 PRE ASSEMBLY TooLS INCLUDED: F 8 mm T-Wrench F 5 mm T-Wrench UNPACKING F 5 mm L-Wrench Place the treadmill carton on a level flat surface. It is recommended that you place a Elite F Screwdriver protective covering on your floor. Take CAUTION when handling and transporting this T5000 unit.
  • Page 6: Assembly Step

    ASSEMBLY STEP 1 Open hardware for step 1. HARDWARE foR STEP 1 : Attach console mast cover to main frame Elite using 3 screws each side. SCREW (1) SCREW (1-1) T5000 Φ 4 x 20 M4 x 12 Qty: 2 Qty: 4 RIGHT CONSOLE MAST SCREW (1-1)
  • Page 7 ASSEMBLY STEP 2 Open hardware for step 2. HARDWARE foR STEP 2 : Pull lead wire through right console mast. Elite BOLT (A) SPRING WASHER (B) ARC WASHER (C) After pulling the lead wire through the mast, the T5000 M8 x 20 mm 8.2 mm Φ8.2 x Φ17 Qty: 6...
  • Page 8 ASSEMBLY STEP 3 Open hardware for step 3. HARDWARE foR STEP 3 : connect handlebar cables, and slide Elite BOLT (E) SPRING WASHER (F) ARC WASHER (G) handlebars into center bar. T5000 M6 x 10 mm 6.2 mm Φ6.2 x Φ14 Qty: 4 Qty: 4 Qty: 4...
  • Page 9 ASSEMBLY STEP 4 Open hardware for step 4. HARDWARE foR STEP 4 : With the console upside down, attach the Elite FLAT WASHER (I) BOLT (J) SPRING WASHER (B) console mast caps to the console T5000 Φ8.2 x Φ16 M8 x 20 mm 8.2 mm Qty: 6 using 6 bolts (J) , 6 spring washers...
  • Page 10 ASSEMBLY STEP 5 Open hardware for step 5. HARDWARE BAG 5: gently place the console on top of the Elite BOLT (J) ARC WASHER (C) console masts. Attach the left side first SPRING WASHER (B) T5000 Φ8.2 x Φ17 M8 x 20mm 8.2 mm using 3 bolts (J), 3 spring washers (b) Qty: 6...
  • Page 11 ASSEMBLY STEP 6 Attach console cables from handlebars HARDWARE foR STEP 6 : to console cables from console. gently tuck excess cable into console before sliding the Elite BOLT (H) SPRING WASHER (B) FLAT WASHER (I) handlebars onto console. T5000 Φ8.2 x Φ16 M8 x 12 mm 8.2 mm...
  • Page 12 ASSEMBLY STEP 7 Open hardware for step 7. HARDWARE BAG 7: Attach left and right drop down Elite SCREW (1-1) BOLT (K) HEX SCREWS (L) handlebar to the long handlebar and T5000 M 4 x 12 M6 x 12mm M6 x 12mm Qty: 4 Qty: 4 Qty: 2...
  • Page 13 ASSEMBLY STEP 8 Elite T5000 YOU ARE FINISHED! Elite T5000 Max. User Weight: 180 kg / 400 lbs Product Weight: 130 kg / 286 lbs Overall Dimension: 171.5 x 85 x 136.5 cm / 67” x 33.5” x 58”...
  • Page 14 TREADMILL OPERATION This section explains how to use your treadmill’s console and programming. The BASIC OPERATION section in the TREADMILL gUIDE has instructions for the following: • LoCATIoN of THE TREADMILL • USING THE SAfETY KEY • foLDING THE TREADMILL •...
  • Page 15 T5000 Elite T5000 Zeit Entfernung Steigung Geschwindigkeit Energy Saver Energiesparmodus Pace Calories Hear t Rate Tempo Kalorien Herzfrequenz WARNUNG! Nur für den Heimgebrauch. WARNING! Model is only for homeuse. Befestigen Sie den Sicherheitsclip an Ihrer Kleidung, bevor Sie das Gerät starten. Attach safety key clip to clothing before starting and remove safety key when not Change Herzfrequenzüberwachungssysteme können ungenau sein.
  • Page 16: Console Operation

    CoNSoLE oPERATIoN QUick adJUst keYpad (k) Note: There is a thin protective sheet of clear plastic on the overlay of the console that should be removed before use. LED DISPLAY WINDoWS: time, incline, distance, speed, date and clock. ALPHANUMERIC DISPLAY WINDoW: calories, heart rate, pace and PROFILE™ display information. DoT MATRIx DISPLAY WINDoW: displays workout level and progress.
  • Page 17: Display Windows

    DISPLAY WINDoWS • TIME: Shown as minutes : seconds. View the time remaining or the time elapsed in your workout. • DISTANCE: Shown as km / miles. Indicates distance traveled. • INCLINE: Shown as percent. Indicates the incline of your walking or running surface.
  • Page 18: Getting Started

    GETTING STARTED DATE AND CLoCK SETUP 1) Check to make sure no objects are placed on the belt that 1) Enter Setup mode: Press and hold the 1 will hinder the movement of the treadmill. and 2 buttons for 3 seconds. 2) Plug in the power cord and turn the treadmill ON.
  • Page 19: Program Information

    PRoGRAM INfoRMATIoN NOTE: If speed or incline are changed during your workout, the remaining segments will be affected accordingly. 1) MANUAL: Adjust your speed and incline manually during your workout. 2) SPEED INTERVALS: Walk or run a series of alternating speed levels. Time-based goal with 10 difficulty levels to choose from. Warm-up and cool-down last 4:00 minutes each and are included in program times.
  • Page 20 3) PEAK INTERVALS: Walk or run a series of alternating speed and incline levels. Time-based goal with 10 difficulty levels to choose from. ( mph ) ( km/h ) Time 2:00 2:00 90 secs 30 secs 2:00 2:00 Time 2:00 2:00 90 secs 30 secs...
  • Page 21 4) STAMINA BUILDER: Promotes weight loss by increasing and decreasing the incline, while keeping you in your fat burning zone. Segments are repeated until selected time is reached. Segment Warm Up Cool Down Level 1 Seconds 4:00 35:00 Incline Segment Warm Up Cool Down Level 2 Seconds...
  • Page 22 PRoGRAM INfoRMATIoN 5) WEIGHT LoSS: Promotes weight loss by increasing and decreasing the speed and incline, while keeping you in your fat burning zone. Speed and Incline changes, segments repeat every 30 seconds. ( mph ) ( km/h ) Time 2:00 2:00 Each segment is 30 seconds...
  • Page 23 6) GoLf CoURSE: Simulates various inclines and yardages for holes on a golf course, with four 9-hole courses and four 18-hole courses. Distance-based goal. 9-Hole golf Course 18-Hole golf Course Total Distance Segment Incline 757m / Tee 1 Distance 309 359 283 256 113 387 351 333 2482 ft.
  • Page 24 8) MoUNTAIN CLIMB: A more-intense version of FOOT HILLS. Simulates a mountain ascent and descent. This program helps tone muscle and improve cardiovascular ability. Incline changes and segments repeat every 30 seconds. Segment Warm Up Cool Down Time 4:00 Each segment is 30 seconds 4:00 Level 1 Level 2...
  • Page 25 9) THR zoNE: Automatically adjusts incline to maintain your Target Heart Rate. Perfect for simulating the intensity of your favorite sport or everyday activity. Time-based goal. 1) Select THR Zone program using and press ENTER on the PROgRAMMINg BUTTON. 2) Select TIME using and press ENTER on the PROgRAMMINg BUTTON.
  • Page 26 10) HR INTERVALS: Automatically adjusts peak and valley incline levels within your desired heart rate. Perfect for providing an intense workout with recovery bursts. Time-based goal. 1) Set WORK interval time using on the PROgRAMMINg BUTTON or the KEYPAD and press ENTER. 2) Set WORK interval target heart rate using or the KEYPAD and press ENTER.
  • Page 27 12-13) 5K & 10K: Walk a series of alternating incline levels. Distance based goal with 4 difficulty levels to choose from. Distance shown as kilometers. Segments repeat until distance is reached. Segment Warm Up Cool Down INCLINE % 4:00 0.16 0.16 0.16 0.16...
  • Page 28 PRofILE™ PERfoRMANCE TRACKER Research shows that those who journal their fitness routines or workouts, on average, achieve greater success than those who do not. Because your new training machine is equipped with HORIZON’s exclusive PROFILE Performance Tracker, you’ve taken an ™...
  • Page 29 PRofILE™ PERfoRMANCE TRACKER This option allows you to view your accumulated data from your last workout. The current workout becomes LAST WoRKoUT: the last workout once a program has ended or the console has been reset. The following information will be shown in each display window: •...
  • Page 30 This option allows you to view the the total accumulated data. The following information will be shown in each LIfETIME ToTAL: display window: • INCLINE - Average incline level. • TIME - Total accumulated time. NOTE: If time is greater than 59:59, the time will no longer display minutes and will display hours only.
  • Page 31 IPoD AND IPHoNE DoCKING STATIoN (ELITE T5000 oNLY) ® ® The iPod docking station is the entertainment solution for your workouts.Various iPod and iPhone models with a dock connector work with docking station provided. iPhone must be set to Airplane Mode to use the iPod control. iPod and iPhone models are sold separately.
  • Page 32 READY REQUIREMENTS Connect your Nike Plus-compatible Nike Plus – compatible iPod or iPhone (See www.apple.com/nikeplus for more information). device to the built-in Made for iPod Before syncing your Apple device to your computer, you must first create a free Nike Plus connector on Nike + iPod compatible account at fitness equipment.
  • Page 33: Using Your Cd / Mp3 Player

    SYNCING TREADMILL WITH PASSPoRT ™ 1) Use the arrow keys on the Passport remote to scroll to the setup icon and press select. 2) Follow the on-screen prompt to press and hold the incline up and stop buttons on the console. 3) Once your snyc is success, your treadmill message bar will change from RF Sync to Passport ready.
  • Page 36 TREADMILL OWNER’S MANUAL T5000 Owner’s Manual 122713’ Rev. 2.6 © 2013 Horizon Fitness...

Table of Contents