Frequently Asked Questions - Cisco DPC3008 User Manual

8x4 docsis 3.0 cable modem
Hide thumbs Also See for DPC3008:
Table of Contents

Advertisement

Chapter 4 Troubleshooting the DOCSIS 3.0 Cable Modem

Frequently Asked Questions

This section provides answers to common questions about the cable modem.
How Do I Configure TCP/IP Protocol?
To configure TCP/IP protocol, you need to have an Ethernet Network Interface Card
(NIC) with TCP/IP communications protocol installed on your system. TCP/IP is a
communications protocol used to access the Internet. This section contains
instructions for configuring TCP/IP on your Internet devices to operate with the
cable modem in Microsoft Windows or Macintosh environments.
TCP/IP protocol in a Microsoft Windows environment is different for each
operating system. Follow the appropriate instructions in this section for your
operating system.
Configuring TCP/IP on Windows 7 Systems
1
Open Network Connections by clicking the Start button, and then clicking
Control Panel.
2
In the Search box, type adapter, and then, under Network and Sharing Center,
click View network connections.
3
Right-click the connection that you want to change, and then click Properties. If
you are prompted for an administrator password or confirmation, type the
password or provide confirmation. The Local Area Connection Properties
window opens.
4
Click the Networking tab.
5
Under This connection uses the following items, click either Internet Protocol
Version 4 (TCP/IPv4) or Internet Protocol Version 6 (TCP/IPv6), and then click
Properties.
6
To specify IPv4 IP address settings, do one of the following:
To get IP settings automatically using DHCP, click Obtain an IP address
automatically, and then click OK.
To specify an IP address, click Use the following IP address, and then, in the
IP address, Subnet mask, and Default gateway boxes, type the IP address
settings.
7
To specify IPv6 IP address settings, do one of the following:
To get IP settings automatically using DHCP, click Obtain an IPv6 address
automatically, and then click OK.
To specify an IP address, click Use the following IPv6 address, and then, in
the IPv6 address, Subnet prefix length, and the Default gateway boxes, type
the IP address settings.
20
4022345 Rev B

Advertisement

Table of Contents
loading

This manual is also suitable for:

Epc3008

Table of Contents