Jenn-Air 204347 Installation Instructions

INSTALLATION
INSTRUCTIONS
PART No. 204347
BUILT-IN ELECTRIC WALL
OVENS
_[] eLIoENMN-Alp A N Ry
FOR 27" WALL CABINET 303s SHADELAN£)
"
INDIANAPOLIS IN46226-0901
IMPORTANT: SAVE FOR LOCAL ELECTRICAL INSPECTOR'S USE.
CAUTION: If cabinet doors are provided above wall oven,
a minimum spacing of 33/4 '' is required for 1/2" thick doors.
For thicker doors, increase the spacing 1" for each 1/4"
J additional thickness.
,._._ CAUTION: Oven venIs.
27" _--_r-_. P4".r_in
CAUTION: Oven vent, /1de no{ obstruct
do no_ obstruct _'_ _J
Alternate _ _ -"--,.f.,_- _-_
location.
See Note 2. ] ]I _J"_
A
28-118" J
Conduit access hole /
ount,lv'a ,
area under plywood floor
if adequate lower cabinet .23.,_-,,_- _ !OT_:_o_ / 7,/
space is available. C _to_C_
Construct 5/8" min. SINGLE and botlem ofunit
plywoodfloor flush WALL OVEN %
with bottom of opening. 23-114_. I
Floor must be capable
'4
_f supporting 240 Ibs. DOUBLE
Jr European style __ _ WALL OVEN
cabinets (flush front) the
required clearance for c
tion of the oven door is a min.
spacing of T/8"between the cutout
and the door, hinge or drawer of the cabinet.
Model A B C 4e_'4'
S ng eWa Oven 28%" 16%" 4" to 33" _
Combination 29"
Wall Oven 477/a" 123/4"to 17W
Double Wall Oven J 50W' 38W' 3" to 12" _
Note 1. Cutout Dimension A 4- _/_6"'
Typical corner screw installation
for all models #8 x 1" screw
Note 2. Locate junction box in shaded area 23/,"
of rear wall so conduit will form a loop when :OMBINATION OVEN NOTE: Donor b lock a irintakeslots
LESS MICROWAVE
along sides and bottom of unit
oven is installed. TRIM
1. Cut hole in cabinet to mount oven. Cutout in cabinet should be level and straight. NOTE: There are no provisions
to level the unit after it is installed. An oven that is not level could cause poor baking results.
2. Install plywood floor as shown above.
3. Attach unit to the cabinet with four No. 8 x 1" screws supplied with unit inside of envelope containing these instructions.
Pre-drill holes in cabinet for attachment screws using 1/8" drill. Oven mounting holes are in each corner of front
panel. For combination units, install trim around microwave with four No. 6 x W' screws supplied with unit. Pre-
drill holes in cabinet for attachment screws using 3/32" drill.
4. See instructions on opposite side of page for electrical hook-up.
5. See User's Manual for operating instructions.
6. CAUTION: Some 27" built-in cabinets may not be wide enough, due to their construction, to allow this installation.
7. Single Wall Oven is also U.L. listed to be installed as a combination unit using microwave models M130 or M166
with Jenn-Air trim kits A526 or A530. Install per instructions packed with trim kits.