Resetting The Microprocessor; Specifications - Denon AVR-E200 Owner's Manual

Resetting the microprocessor

Perform this procedure if the display is abnormal or if operations cannot be performed.
Note that when the microprocessor is reset, all the settings are reset to their default values.
X
SOURCE SELECT 0
SOURCE SELECT 1
1
Turn off the power using X .
2
X
Press while simultaneously pressing
1 .
3
Once the display starts flashing at intervals of about 1 second, release the two
buttons.
If in step 3 the display does not flash at intervals of about 1 second, start over from step 1.
DVD
SOURCE SELECT 0 SOURCE SELECT
and

Specifications

n Audio section
• Power amplifier
Rated output: Front:
Center:
Surround:
Output connectors: 6 – 16 Ω/ohms
• Analog
Input sensitivity/Input impedance: 200 mV/47 kΩ/kohms
Frequency response: 10 Hz – 100 kHz — +1, –3 dB (DIRECT mode)
98 dB (IHF–A weighted, DIRECT mode)
S/N:
n Video section
• Standard video connectors
Input/output level and impedance: 1 Vp-p, 75 Ω/ohms
Frequency response: 5 Hz – 10 MHz — 0, –3 dB
n Tuner section
(Note: μV at 75 Ω/ohms, 0 dBf = 1 x 10 –15 W)
Receiving Range: 87.5 MHz – 107.9 MHz
Usable Sensitivity: 1.2 μV (12.8 dBf)
50 dB Quieting Sensitivity: MONO
S/N: MONO
STEREO
Total harmonic Distortion (at 1 kHz): MONO
STEREO
n General
Power supply: AC 120 V, 60 Hz
Power consumption: 330 W
Power consumption in standby mode: 0.3 W
For purposes of improvement, specifications and design are subject to change without notice.
58
75 W + 75 W (8 Ω/ohms, 20 Hz – 20 kHz with 0.08 % T.H.D.)
110 W + 110 W (6 Ω/ohms, 1 kHz with 0.7 % T.H.D.)
75 W (8 Ω/ohms, 20 Hz – 20 kHz with 0.08 % T.H.D.)
110 W (6 Ω/ohms, 1 kHz with 0.7 % T.H.D.)
75 W + 75 W (8 Ω/ohms, 20 Hz – 20 kHz with 0.08 % T.H.D.)
110 W + 110 W (6 Ω/ohms, 1 kHz with 0.7 % T.H.D.)
[FM]
520 kHz – 1710 kHz
18 μV
2.8 μV (20.2 dBf)
70 dB (IHF–A weighted, DIRECT mode)
67 dB (IHF–A weighted, DIRECT mode)
0.7 % (1 kHz)
1.0 % (1 kHz)
[AM]