DJG Alpha Omega Owner's Manual

Alpha omega 3-in-1
Hide thumbs Also See for Alpha Omega:

Advertisement

Replacement Parts List
NOTE: If requested color is not available, similar color will be
substituted.
Part
Cost
Crotch Strap/Buckle $4.99 X______= $ ______________
Harness Strap . . . . .$2.00 X______= $ ______________
Full Wrap . . . . . . .$42.00 X______= $ ______________
5-point Pad
Harness Retainer . . .$1.50 X______= $ ______________
Locking Clip . . . . . . .$2.50 X______= $ ______________
Tether Kit . . . . . . . .$9.99 X______= $ ______________
Latch Kit . . . . . . . .$24.99 X______= $ ______________
Instructions . . . . . . .$0.00 X______= $ ______________
Merchandise Total
Shipping and handling:
Up to $25.00 . . . . . . . . . .$5.95
$25.01 to $50.00 . . . . . . .$6.95
$50.01 to $75.00 . . . . . . .$8.95
$75.01 to $100.00 . . . . . .$9.95
Sales Tax
(Indiana, California, Arkansas, and Massachusetts residents add applicable
sales tax.
Grand Total
No shipping and handling on instructions for quantities under 6. Add $.50 for
each instruction over 6, then add applicable shipping and handling.
Fill Out For Credit Card
Visa
Card Exp. Date: ______________________________
Cardholder's Name: __________________________
Card Number: ______________________________
Signature____________________________________
Quantity Total Cost
$______________
$ ______________
$100.01 to $150.00 . . . . .$10.95
$150.01 to $200.00 . . . . .$11.95
$200.01 and up . . . . . . . .$13.95
Outside Continental USA $10.00
$ ____________
$ ______________
Mastercard
54
Alpha Omega
3-In-1
Owner's Manual
www.djgusa.com
Read all instructions
BEFORE USING
this child restraint.
KEEP INSTRUCTIONS FOR FUTURE USE.
IMPORTANT!
Failure to follow the warnings on the labels
and in the instruction manual can result in
the death or serious injury of your child.
Para recibir las instrucciones en español, llame al
1-800-544-1108 o solicitarse por escrito al dirección por arriba.
Eng. 4358-3186
®
This child
restraint is
designed for
use by children
whose:
Weight:
5-80 pounds
(2.3-36 kg)
Height:
19-52 inches
(48-132 cm)

Advertisement

Table of Contents
loading

Summary of Contents for DJG Alpha Omega

  • Page 1 Eng. 4358-3186 Replacement Parts List Alpha Omega ® NOTE: If requested color is not available, similar color will be substituted. 3-In-1 Part Cost Quantity Total Cost Crotch Strap/Buckle $4.99 X______= $ ______________ Owner’s Manual Harness Strap ..$2.00 X______= $ ______________ Full Wrap .
  • Page 2: Table Of Contents

    LATCH ................27-30 restraint, please contact our Consumer Relations Department at: Forward-Facing Use ..............31 Forward-Facing Installation ............32 Dorel Juvenile Group, Inc. Vehicle Belt ................33-34 Website: www.djgusa.com LATCH ................35-37 Adjusting the Tether Strap ............38-39 Belt-Positioning Booster Use ............40...
  • Page 3: Warnings

    WARNING WARNING Failure to follow these warnings can result in The vehicle or LATCH belt must stay the serious injury or death of your child. To tight at the belt path.When you switch from help you recognize those instructions which one mode to the next, review the sections of this instruction manual that apply to that are most critical for your child’s safety, we...
  • Page 4: Registration And Recall Information

    1. Park in the shade or where sun does not directly hit the child restraint. Dorel Juvenile Group does not recommend 2. Cover the child restraint with a sheet or blanket the use of any child restraint accessories when not in use.
  • Page 5: Know Your Vehicle

    Know Your Vehicle Your vehicle’s features may be considerably different than those pictured here. Consult your vehicle owner’s manual to help identify your vehicle’s specific features. A.Anchor Bracket D.Air Bag For Top Anchorage Strap (Consult your vehicle (Forward-Facing Only) owner’s manual for all air bag locations) LATCH Anchors Seat Bight...
  • Page 6: Child Restraint Features

    Child Restraint Features Front Back Top Anchorage D. Harness Bracket (Tether) Strap & Pillow Buckle Plate Instructions Hook Shoulder Belt Buckle LATCH Belt Harness/Headrest Guide Harness Release Adjuster (may be inbetween Adjustable Lever pad and shell) Locking Clip Headrest Recline Lever (behind harness) Infant Insert Harness...
  • Page 7: Choosing Restraint And Position

    Weight and Height Chart Choosing Restraint and Position Your child’s height, weight and age determine how your child restraint should be placed in the vehicle and which Height restraint should be used. See chart on next page. 19 21 23 25 27 29 31 33 35 36 37 39 40 41 43 45 47 49 51 52 Rear-Facing using 5-point harness Child and child restraint...
  • Page 8: Preparing Child Restraint To Fit Your Child

    Place the child’s bottom Preparing Child Restraint to Fit and back flat against the Your Child child restraint.This will increase comfort and allow You MUST make these adjustments with your the harness to properly child before you install the child restraint in the tighten.
  • Page 9 Squeeze the metal bar on Securing Your Child in the Child the back of the seat. Move harness/headrest adjuster Restraint up or down to the position that correctly fits your child. Release bar into slot to Position harness straps over lock.
  • Page 10: Removing Your Child From The Child Restraint

    Pull on harness adjustment Removing Your Child From the strap to tighten harness snugly. Child Restraint NOTE: A snug strap Press on release button and pull apart. should not allow any slack. It lies in a relatively straight line without sagging.
  • Page 11: Reclining The Child Restraint

    Choosing LATCH or Vehicle Belts Reclining the Child Restraint The LATCH System This child restraint has 3 recline positions when used with the base: LATCH means Lower Anchor bars Upright and Semi-reclined Anchors and Tethers for (forward facing only) and CHildren.
  • Page 12: Knowing Your Vehicle Belts

    Manual Belts Knowing Your Vehicle Belts Manual lap belts are Not all vehicle belts will work with this child restraint. common in the center rear You must determine if your vehicles belts are compatible seat and can allow the child with this child restraint.
  • Page 13: Locking Clip

    Rear-Facing Use Locking Clip NOTE: You do not need a locking clip when using this seat as an belt-positioning booster. Remove the locking clip when the seat belt is not being used with a child restraint. The locking clip is located on the back of the seat.
  • Page 14: Rear-Facing Installation

    Rear-Facing Installation Rear-Facing Installation with Vehicle Belt: After deciding whether to use your Vehicle Belts or LATCH, be sure to read the warnings below as they Place child restraint rear- pertain to both systems. facing in the back seat. With child restraint in the You may need to remove most reclined position, the base for narrow vehicle...
  • Page 15: Latch

    Push down firmly on the Rear-Facing Installation with child restraint and pull up LATCH: Install LATCH Belt on belt to tighten. For a manual belt, refer to “Knowing your Vehicle Belt” section. Pull up on Do not use the LATCH shoulder strap to remove system along with the any slack.
  • Page 16 Push LATCH hook Rear-Facing Installation with through the rear-facing LATCH: Install in Vehicle belt path slot. Place child restraint rear- facing in the back seat. Tuck the top NOTE: anchorage strap’s hook under the child restraint. Fasten one LATCH belt hook to the anchor in the vehicle seat located in the Pull other end of LATCH...
  • Page 17: Forward-Facing Use

    After checking for hot Forward-Facing Use seat and buckles, place child in child restraint. See “Securing Your Child in the Child Restraint” section. Lap Belt Lap/Shoulder Belt Refer to the Weight and To remove LATCH: Height Chart to make Push in on release button sure your child is at the and pull LATCH adjuster proper weight and height...
  • Page 18: Forward-Facing Installation

    Forward-Facing Installation Forward-Facing Installation with Vehicle Belts: After deciding whether to use your Vehicle Belts or LATCH, be sure to read the warnings below as they Face child restraint pertain to both systems. forward in the vehicle seat either in the reclined or upright position.
  • Page 19: Latch

    With weakest hand at belt Forward-Facing Installation with path, tilt and push the LATCH Belt: Install LATCH Belts child restraint forward and back, and from side to NOTE: Do not use side. If the seat belts do LATCH system along not loosen, your child with the adult lap or restraint should be secure.
  • Page 20 Place one knee in the child After checking for hot restraint and push down seat and buckles, place firmly while pulling up on your child in the child the loop to tighten belt. restraint as described in the “Securing Your Child in the Child Restraint”...
  • Page 21 To Attach Top Adjusting the Top Anchorage Anchorage Strap: Put Strap knee in child restraint and push down; attach The top anchorage strap is used for the forward-facing hook to anchor in vehicle position only. (See weight and height chart.) to estimate how much adjustment you need, Most vehicles made after 9/1/99 already have the anchor...
  • Page 22: Belt-Positioning Booster Use

    Belt-Positioning Booster Use Removal of Seat Base Refer to the Weight and Base must be removed for use as Height Chart to make Belt-Positioning Booster. sure your child is at the proper weight and height to use the belt- positioning booster. Lap/Shoulder Belt Do not use LATCH when using the Belt-...
  • Page 23: Removal Of Harness

    From under seat, push Removal of Harness down on large tab and pull metal clip out. Harness must be removed for use as a Belt-Positioning Booster. From the back of the seat, unfasten harness from harness bracket. Insert metal clip up through the shell and pad.
  • Page 24: Belt-Positioning Booster Installation

    Secure the shoulder belt Belt-Positioning Booster through one of the Installation notches in the shoulder belt guide.The belt should cross the base of Rotate recline stand the child's neck and down, then push up firmly across the chest (not the until it locks in place.
  • Page 25: Reinstall Harness And Base

    Pull harness through the Reinstall Harness and Base back. Make sure the harness goes OVER the Reinstall Harness: metal bar of the harness/headrest adjuster. Fit the buckle strap down through the slot in the seat. Make sure buckle faces out. Slide metal clip under Fit loops on harness ends small tab and push down...
  • Page 26: Removing Seat Pad For Cleaning

    Work pad off shoulder belt Removing Seat Pad for Cleaning guides and off of headrest. Remove base and harness as described in the “Belt- Positioning Booster” section. From underneath bottom of shell, release the 2 elastic straps (A). Undo the 4 clips on the side of the shell (B).
  • Page 27: Trouble Shooting

    Trouble Shooting Installation Tips: If your child restraint is not held securely In the rear-facing position, the harness strap must be by the belt: positioned at or below the child’s shoulders. In the Press down firmly on the child restraint and remove all the forward-facing position the harness must be positioned at slack in the belt.
  • Page 28: Warranty

    Warranty Replacement Parts Order Form Dorel Juvenile Group, Inc. (DJG) warrants this product to the Complete the form below. Your model number with color original retail purchaser as follows: code and manufacturer date code MUST be included on the This product is warranted against defective materials or form to ensure proper replacement parts.

This manual is also suitable for:

Alpha omega 3-in-1

Table of Contents