Display Messages - Jacuzzi Select Series Owner's Manual

Automatic Filter Cycles
Your spa will automatically filter itself for 2 hours twice each day. The first filter cycle will begin 1 minute after the
spa is energized. The second filter cycle will begin twelve hours after the start of the first cycle. The low-speed jets
will constantly run during the filter times (unless the high-speed jets are on) and the heater will be enabled.

Display Messages

These are some of the messages you will see on the center display.
Message Meaning
Overheat Protection: Spa is deactivated. If a malfunction occurs and the spa water reaches 112°F, the
system will completely shut down.
Danger: DO NOT ENTER THE WATER. Turn off all power to the spa and contact your dealer or
service organization. Press any panel button to reset.
Flow Switch: A pressure switch has malfunctioned. Contact your dealer or service organization.
Open Sensor: Spa is deactivated. Either the high limit or the water temperature sensor is nonfunctional.
Contact your dealer or service organization.
OPERATION
7