Related Manuals for Peco 12031301, 12031302
Summary of Contents for Peco 12031301, 12031302
- Page 1 PECO PECO PECO PECO PECO MODEL 12031301, 12031302 GRAVELY 100 SERIES MOWERs OPERATOR’S MANUAL ASSEMBLY MANUAL PART#: Q0322 GRASS COLLECTION DESIGNED FOR: OPERATION $4.00 SYSTEM MAINTENANCE REV: 0...
-
Page 2: Table Of Contents
PTO GRASS COLLECTION SYSTEM SECTION Safety - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - 2 Safety Alert Symbols - - - - - - - - - - - - - - - - - - - - - - 3 Warranty - - - - - - - - - - - - - - - - - - - - - - - - - - - - - 4 INTRODUCTION AND DESCRIPTION - - - - - - - - - - - - - - 5 1-1 Introduction - - - - - - - - - - - - - - - - - - - - - - - - - 5... -
Page 3: Safety Alert Symbols
WARNING! NEVER operate the unit unless the discharge guard and either the deflector assembly or the vacuum collector adapter are fastened securely in place. WARNING! Do not work around the mower deck boot or the blower area until you are certain that the mower blades and the blower impeller have stopped rotating. -
Page 4: Warranty
PECO LIMITED WARRANTY FOR NEW PRODUCTS A. WHAT IS WARRANTED? PECO extends the following warranties to the original purchaser of each new PECO consumer product subject to the following limitations: 1. PRODUCT WARRANTY: Any part of any consumer product, which is defective in material or workmanship as delivered to the purchaser will be repaired or replaced, as PECO elects, without charge for parts or labor, if the defect appears within 12 months from the date of delivery of the product to the original purchaser. -
Page 5: Introduction And Description
INTRODUCTION AND DESCRIPTION 1-1 Introduction We are pleased to have you as a PECO customer. Your collection system has been designed to give you a low maintenance, simple, and effective way to collect the grass clippings from your mower. This manual is provided to give you the necessary instructions to properly mount and operate the collection system on your mower. -
Page 6: Attaching Muffler Guard
2-2 Attaching Muffler Guard Locate the two exhaust diverters (P#J0251 w/ 1-1/4” ID, P#J0250 w/ 1-3/8” ID) and clamp kit P#(X1046) provided in the hardware bag. Fasten the correct size exhaust deflector onto the mower’s exhaust and aim the exhaust as shown in Figure 3. Next, fasten the exhaust diverter by using the clamp kit. -
Page 7: Saftey Interlock Connection
2-4 Safety Interlock Harness Connection The safety interlock harness is located inside of the right PTO arm assembly (Figure 7). To install the harness to the mower, lift the hood of the mower for engine compartment access. Route the harness as shown towards the parking brake switch bracket on the mower (Figure 8). - Page 8 Figure 11. Exploded View Of The A0549 - Bagger Assembly (1) V0002 - PLASTIC TOP (2) K1126 - 1/4”-20 FLANGE NUT (2) K0037 - 1/4” FLAT WASHER (1) C0048 - LATCH MOUNT BRACKET (2) K1025 - 1/4”-20 x 1” CARRIAGE BOLT (2) J4005 - FLEXIBLE DRAW LATCH...
- Page 9 Exploded Parts View Figure 12. Exploded View Of The Blower Assembly Figure 13. Exploded View Of The A0506 - PTO Assembly...
- Page 10 Parts View Item Part No. Qty. Description 1 - - - - E6009- - - - - - 1 - - - - Blower Cone 8” 2 - - - - K1159 - - - - - - 2 - - - - 5/16”-18 x 2” HHCS 3 - - - - A0914- - - - - - 1 - - - - 4 Blade Impeller Assembly 4 - - - - K1193 - - - - - - 4 - - - - 3/8”-16 x 1-1/2”...
-
Page 11: Belt Installation
2-5 Belt Installation Loosen the (2) bolts that secure the gear box assembly P#(A0429) to the PTO mount plate (Figure 14). Loosen the adjustment bolt P#(K0348) until the gear box assembly is at its far left adjustment (the gear box is moved towards the mower’s engine pulley). -
Page 12: Attachment Of Upper Frame Assembly To The Lower Frame
2-8 Attachment Of Upper Frame Assembly To The Lower Frame NOTE: During this step, it is suggested that two people install the top frame to the lower frame. Using two people to raise the top frame, lift the top frame above the lower frame making sure the bag frames are located away from the engine as shown in Figure 18. -
Page 13: Adjustment Of The Lengths Of Hoses
2-11 Adjustment Of The Lengths Of Hoses The hoses in steps 2-12 and 2-13 must be cut to fit your machine. Follow steps 2-12 and 2-13. Do not cut the hoses until you have tried to fit them on your machine. Remember that the hoses have to be long enough to allow for enough clamping surface between the inlet, blower assembly, and the deck boot. -
Page 14: Installation/Removal Of Collection Bags
2-16 Installation/Removal Of Collection Bags To install the bag onto the bag ring, first make sure the bag ring end caps are fastened to the bag ring. Place the seam openings of the bag onto the bag ring openings and turn the bag until the slot bracket in the bag ring is protruding from the opening in the bag (Figure 23). -
Page 15: Final Checks
2-17 Final Checks To check the operation of the safety interlock harness perform the following: A. Start mower B. While seated in the operator’s seat, rotate the engagement handle of the collection system away from the mower. C. With the blower engaged, stand up from the operator’s seat. -
Page 16: Lubrication
3. Make sure all shields are in place and in good condition. Repair or replace any missing or damaged shields. 4. Perform lubrication per paragraph 4-2. 5. Listen for abnormal sounds, which might indicate loose parts, damaged bearings, or other damage. Correct any deficiency before continuing operation. -
Page 17: Safety Decals
To promote safe operation, PECO supplies safety decals on all products manufactured. Damage can occur to safety decals either through shipment, use or reconditioning. Contact your local Service Center for replacement decals. Part #: R1054 Part #: R1050 Part #:R1083 SAFETY DECALS Part #: R1057 Part #: R1065... -
Page 19: Notes
NOTES... - Page 20 Turn any PECO Lawn Vac into a total lawn grooming tool with the PECO With your PECO Wand Attachment you will double the ability of your PECO Lawn Vac. Using the same powerful vacuum/blower that makes your Lawn Vac work so well, you will be able to get to all those hard-to-reach places where you needed a rake or broom before.