Grandstream Networks GXP1405 User Manual page 30

Support SIP Instance ID Selects whether or not SIP Instance ID is supported.
NAT Traversal
SUBSCRIBE for MWI
SUBSCRIBE for
Registration
Feature Key
Synchronization
PUBLISH for Presence
Proxy-Require
Voice Mail UserID
Send DTMF
DTMF Payload Type
Early Dial
Dial Plan Prefix
Grandstream Networks, Inc.
This parameter activates the NAT traversal mechanism. It has options: No, STUN,
Keep-Alive, UPnP, Auto, VPN.
If selecting STUN and a STUN server is also specified, the phone performs
according to the STUN client specification. Using this mode, the embedded STUN
client detects if and what type of NAT/Firewall configuration is used. If the detected
NAT is a Full Cone, Restricted Cone, or a Port-Restricted Cone, the phone will use
its mapped public IP address and port in all of its SIP and SDP messages.
If selecting Keep-Alive with no specified STUN server, the GXP1400/1405 will
periodically (every 20 seconds or so) send a blank UDP packet (with no payload
data) to the SIP server to keep the "hole" on the NAT open.
Default is "No". When set to "Yes", a SUBSCRIBE for Message Waiting Indication
will be sent periodically.
Default is "No". When set to "Yes" a SUBSCRIBE for Registration will be sent
periodically.
Default is "No". This option is to synchronize DND/Call Forward features with
Broadsoft. When set to "Yes", a SUBSCRIBE will be sent out periodically to the
server. Then when DND/Call Forward features (Call Forward No Answer,
Unconditional Call Forward and Call Forward on Busy) are configured or changed
on the phone and the Broadsoft server side, those features will be synchronized on
the phone side and the Broadsoft server side.
Enable Presence feature.
SIP Extension to notify SIP server that the unit is behind the NAT/Firewall.
When configured, user can access messages by pressing "MSG" button. This ID is
usually the VM portal access number.
This parameter specifies the mechanism to transmit DTMF digit. There are 3
supported modes: in audio which means DTMF is combined in audio signal (not
very reliable with low-bit-rate codec), via RTP (RFC2833), or via SIP INFO.
Sends DTMF using RFC2833. The default is 101.
Default is "No". Use only if proxy supports 484 responses.
Sets the prefix added to each dialed number.
GXP1400/1405 User Manual
Firmware version: 1.0.1.83
Page 29 of 36
Last Updated: 08/2011