Using Features Of Lip-8002/8002A Phone; Receiving A Call; Placing A Call; Putting A Call On Hold - LG-Ericsson LIP-8002 User Manual

For ipecs
Hide thumbs Also See for LIP-8002:
Table of Contents

Advertisement

3. Using Features of LIP-8002/8002A Phone

3.1. Receiving a Call

When you receive a call, your phone rings, the LCD displays the incoming call information.
To answer a ringing call:
o Lift the handset or press the speakerphone button.
To end the call:
o Hang up the handset. If using the speakerphone, press the speakerphone button.

3.2. Placing a Call

You place calls with the handset on-hook or off-hook. Similar to your mobile phone, the LIP-8002/8002A
Phone uses a technique called 'store and forward dialing'. After you dial a digit, the IP Phone waits about
3 seconds for additional digits. If you do not dial additional digits, the IP Phone sends the digits you
dialed to the call server for processing. To send the digits immediately, press the # button to indicate
dialing is complete, and then the IP Phone sends the number to the call server.
To place a call:
o Lift the handset. You may press the speakerphone button to activate the speakerphone.
o Dial the destination number. After a short delay, the IP Phone sends the number, or dial # to send the
dialed digits immediately.
o When the called party answers, begin speaking, the LCD displays the elapsed call time.
To end the call,
o Hang up the handset. If using the speakerphone, press the speakerphone button.

3.3. Putting a Call on Hold

You can place a call in a waiting state where the held party cannot hear you and you cannot hear the held
party. The held party receives MOH (Music-On-Hold), if configured in the call server.
While a call is on hold, you can answer or place other calls and can toggle between calls on hold. With
Call Hold Ringback enabled, the IP Phone rings as a reminder of calls on hold when you return the IP
Phone to idle. Refer to your system administrator or Installer Guide for further information.
To place a call on hold:
o Assign the Hold function to the flexible button.
o Press the Hold flexible button. The call status changes to hold and you receive dial tone.
To retrieve the hold call:
o Press the OK button, when the LCD displays the call on hold.
To toggle between two calls:
o Press the Up/Down navigation button, the active call status changes to hold and the call on hold
connects.
LIP-8002/8002A iPECS IP Phone
4
User Guide

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Lip-8002a

Table of Contents