Advertisement
Quick Links
ATA
Jumper Settings
S tand Alone
M aster with Slave Present
S lave to Master
X
= PK is a Parking position. The presence or absence of this jumper has no effect on the drive.
Labeling may indicate to place this jumper when configuring as a slave. This is to provide for
retention of the jumper in the event it is needed later.
Jumper Locations
The Fireball SE disk drive has only one location where user configurable jumpers are found. The
jumper block is incorporated into the IDE / ATA cable connector. Using the jumper pins you can
establish the drive Master/Slave configuration.
1 of 1
Fireball SE
Jumper Settings
DS
CS
PK
ON
OFF
X
ON
OFF
X
OFF
OFF
X
Rsvd
OFF
OFF
OFF
Advertisement
Related Manuals for Quantum Quantum Fireball SE
Summary of Contents for Quantum Quantum Fireball SE
- Page 1 Fireball SE Jumper Settings Jumper Settings Rsvd S tand Alone M aster with Slave Present S lave to Master = PK is a Parking position. The presence or absence of this jumper has no effect on the drive. Labeling may indicate to place this jumper when configuring as a slave. This is to provide for retention of the jumper in the event it is needed later.
- Page 2 Fireball SE fireball_se_jumper.pdf BIOS Settings The following BIOS parameters are provided for customers needing to manually configure the Quantum disk drive. Both base 2 and base 10 capacity values are displayed. Cylinders Heads Sectors Base 2 Capacity B ase 10 Capacity 2 .1 GB 4092 2,014 MB...
- Page 3 Fireball SE fireball_se_jumper.pdf The drawing above displays the jumper block physical location. SCSI ID Settings The following table identifies the various SCSI ID values and the jumper positions required to set them. Drive ID ID 0 ID 1 ID 2 ID 3 ID 4 ID 5...