Do not use this car seat until you read and understand these instructions!
Incorrect usage can mean serious injury or death to a child in a sudden stop or accident!
If you need help, please call 1-800-837-4044
* Remove Current Harness Straps:
* Install
New Harness
Straps:
1 With both harness straps towards car seat
and short strap towards you:
. Insert anchor into slot in bottom of
shield exactly as shown.
.
Pull harness strap to check that
anchor does not come out.
1
Loosen harness straps:
. Lift Adjuster Lever on lower front of
car seat.
. Pull harness straps.
2
Buckle latch tongue into opening. -
2
Remove harness strap loops
from Splitter Plate.
Loops
Splitter Plate
3
Thread right harness strap through
right side of harness tie (child's right).
3
Pull harness straps out of current slots.
4
Remove harness tie from harness
straps.
4
Thread harness straps through desired
slots of seat pad and car seat shell.
IMPORTANT:
.
For rear-facing infants,
bottom
or
middle slots, which are at or just below
shoulders, must be used.
.
For forward-facing
toddlers,
top
slots must be used.
5
Push red button on lower front
of car seat to unbuckle latch tongue.
5
Slide loop on end of each harness
strap onto Splitter Plate.
Red Button
Shield
\
6
Cut harness strap close to shield.
NOTE: Do not attempt to remove
metal anchor inside shield. Loose
metal anchor may remain inside
--po
shield.
;
Cut Here
Close To Shield
6
Make sure Splitter Plate Strap
passes between recliner stand and
car seat shell (see arrow).
NOTE:
Splitter Plate Strap must
not be twisted.
~
'I
~I
Throw harness strap away.
Splitter Plate Strap
~
~
01
ENGLISH
PM-O548AA 4197