Buffalo WZR-HP-AG300H User Manual page 45

Chapter 1 Product Overview
5
Router LED (Green)
On:
Off:
6
Diag LED (Red)
Diag LED Meaning
status
2 blinks * Flash ROM error
1
3 blinks * Ethernet (wired) LAN
1
error
4 blinks * Wireless LAN error
1
5 blinks IP address setting error
Continuously Updating the firmware
blinking Saving settings
*2
Initializing settings
*1 Unplug the AC adapter from the wall socket, wait for a few seconds, and then plug it again. If the
light still flashes, please contact technical support.
*2 Never unplug the AC adapter while the Diag LED is blinking continuously.
7
Movie Engine LED (Blue)
On:
Off:
8
Movie Engine Switch
Switches the movie engine function between enabled and disabled.
On:
Off:
WZR-HP-AG300H User Manual
Router functionality is enabled.
Router functionality is disabled.
This indicates the status of this unit depending on the number of blinks
per cycle.
Note: When the unit is first turned on or restarted, the Diag LED will blink
for almost a minute during boot. This is normal.
Status
Cannot read or write to the flash memory.
Ethernet LAN controller is malfunctioning.
Wireless LAN controller is malfunctioning.
Because the network addresses of both the Internet port (WAN
port) and the LAN port are the same, it is not possible to establish
communication. Change the LAN side IP address of this unit.
Updating the firmware.
Saving the settings.
Initializing the settings.
Movie Engine functionality is enabled.
Movie Engine functionality is disabled.
Movie Engine functionality is enabled.
Movie Engine functionality is disabled.
10