Access Point Attached To A Network / Internet Gateway - Buffalo WZR-HP-AG300H User Manual

 Enter your country in "Regulatory Domain"
 In the "Antenna Gain" field, please enter the gain of the antenna on
your router. The firmware will adjust the transmit power accordingly
to meet regulatory requirements. Please keep in mind that very long
cables can dampen the HF signal thus reducing the usable antenna
gain.
 Configure "Wireless Mode" to "AP"
 Set your desired wireless mode in "Wireless Network Mode". Please
note that mixed modes will lead to reduced performance because of
maintaining compatibility.
 Enter a name for your wireless network into "Wireless Network Name
(SSID)"
 Click "Save"
Wireless -> Wireless Security
 Choose and configure a security mode.
insecure and should only be used if no other option is available.
 Click "Apply Settings"
You can now connect the router to the Internet and your local network.
After you successfully connect wireless devices, they will then be
displayed on the "SysInfo" and "WLAN Status" pages.
3.1.1.

Access Point attached to a network / Internet gateway

Setup -> Basic Setup
 WAN Setup
o For "Connection Type", choose "Disabled".
 Network Setup
o Enter the desired LAN-side IP address for the router into "Router
IP".
o Set the "DHCP Type" to "DHCP Server" (this is the default).
o "Disable" "DHCP Server".
 Time Settings
o Choose your time zone.
 Click "Save".
Wireless -> Basic Settings
 Enter your country in "Regulatory Domain"
 In the "Antenna Gain" field, please enter the gain of the antenna on
your router. The firmware will adjust the transmit power accordingly
to meet regulatory requirements. Please keep in mind that very long
cables can dampen the HF signal thus reducing the usable antenna
gain.
 Configure "Wireless Mode" to "AP"
 Choose a wireless mode in "Wireless Network Mode". Please note that
mixed modes will lead to reduced performance because of maintaining
compatibility.
- 19 -
Please note that WEP is