Code Setup (Programming The Remote Control); Programming By Brand Code Search - Silvercrest SFB 10.1 A1 Operating Manual

Code Setup
3 Programming methods are available for the remote control:
Programming by brand code search, by automatic code
search and by direct code input (manual).
First you should use the brand code search since this method is
the fastest way of programming if the manufacturer of your de-
vice is itemized in the code list. As second is recommended the
direct code input followed by the automatic code search.

Programming by brand code search

With this method you select the brand and code direct via
the LCD display q.
Observe the following operational references to programme
the remote control:
1. Press the device button e for the device that you want to
programme the remote control.
2. Hold down the S button r for a little longer than 3 sec-
onds. Carry out entries in the menu quickly because after
approx. 15 seconds without an entry the menu will be
ended.
3. In the LCD display q "CODE SETUP" appears. Press the
OK button l. "ENTER CODE" now appears in the LCD
display q. With the  buttons t select "BRAND
CODE" and confirm with the OK button l.
4. Now appears the alphabetical first brand name from the
list of pre-programmed devices.
5. With the 34 buttons t select the various brand names.
6. To make access easier you can skip directly to specific let-
ters of the alphabet with the number buttons o:
2 => A
6 => M
Example With button number 5 the display skips to the
letter "J". The first brand is "JVC"*. If, for example, you
own a "Kenwood"* brand device, continue leafing with
the 4 button t until this brand name appears. (* All
brand names used here are trademarks of the corre-
sponding manufacturer.)
7. The majority of manufacturers use several different codes
for the remote control. You must now ascertain which of
the available codes is best suited to your device. On the
right underneath the brand name the relevent code will
be shown in the LCD display q.
8. Point the remote control to the relevent device and press
the function buttons to test the code (except 34t,
OK l, EXIT y, or the number buttons o).
(Programming the remote control)
3 => D
7 => P
- 11 -
4 => G
8 => T
5 => J
9 => W