Grandstream Networks HT701 User Manual page 43

SLIC Setting
Caller ID Scheme
Polarity Reversal
Loop Current
Disconnect
Loop Current
Disconnect Duration
Enable Hook Flash
Hook Flash Timing
On Hook Timing
Gain
Disable Line Echo
Canceller (LEC)
Ring Tones
FIRMWARE VERSION 1.0.3.1
transmission mode. Select between Disabled, Enabled but not Forced, and Enabled
and Forced. Default is Disabled.
Dependent on standard phone type (and location)
Bellcore/Telcordia, ETSI-FSK, ETSI-DTMF, SIN 227 – BT, & NTT Japan
Default is No. If set to "Yes", polarity will be reversed upon call establishment and
termination.
Default is No. Set it to Yes if the traditional PBX you are using with HT70X uses this
method for signaling call termination. Method initiates short voltage drop on the line
when remote (VoIP) side disconnects an active call.
Default value is 200. Here can be configured duration of such voltage drop described in
topic above. HT70X supports a Duration Range from 100 to 10000 ms.
Default is Yes. If set to "No", FLASH button could only be used for terminating calls.
Time period when the cradle is pressed (Hook Flash) to simulate FLASH. To prevent
unwanted activation of the Flash/Hold and automatic phone ring-back, adjust this time
value. Default values are 300 minimum and 1100 maximum. HT70X supports a
range from 40 to 2000 ms.
On-hook timing is the minimum time for an on-hook event to be validated. Default
value is 400 . HT70X supports a range from 40 to 2000 ms.
Voice path volume adjustment.
•
Rx is a gain level for signals transmitted by FXS
•
Tx is a gain level for signals received by FXS.
Default = 0dB for both parameters. Loudest volume: +6dB Lowest volume: -6dB.
User can adjust volume of call on either end using the Rx Gain Level parameter and
the Tx Gain Level parameter located on the FXS Port Configuration page.
If call volume is too low when using the FXS port (ie. the ATA is at user site), adjust
volume using the Rx Gain Level parameter under the FXS Port Configuration page.
If voice volume is too low at the other end, user may increase the far end volume using
the Tx Gain Level parameter under the FXS Port Configuration page.
Default is No. If set to "Yes" LEC will be disabled per call base. Recommended for
FAX/Data calls.
This function lets you configure ring tone cadence preferences. User has 10 choices.
The configuration, completed in Distinctive Ring Tones block in the same page, applies
to ring tones cadences configured here.
HT70X USER MANUAL Page 43 of 52