R
eCommended toolS
Check Step 8:
A
Tools (Figure 8):
B
Additional tools to make installation easier:
•
Slotted and phillips screw-driver bits
•
Stud finder
•
Sheet-metal cutting snips
D
R
e
G
Check Step 9:
emoVe
xiStinG
aRaGe
d
l
ooR
oCkS
Check that the garage door locks, rope, and T-Handles are
removed from the garage door before starting the installation .
A
If your garage does not have a separate entry door, it is
highly recommended to install a Genie Emergency Release
Kit (GER-2) . Emergency Release Kit lets you open the garage
door from outside if there is a ppower failure . (Please see
Accessories Order Form on page 14 . )
Before going further, get any items and tools if needed
for your installation
p
Garage door frame reinforcement brackets, screws, bracing
or reinforcement kits (dealer)
p
Lag Screws (1-1/4”) for a wood door less than 2” thick (store)
p
Electrical outlet and/or wiring (supplied by a licensed electrician)
p
Sufficient angle iron or strapping for hanging Power Head (store)
p
60 Watt light bulbs (Rough service bulbs recommended)(store)
p
GER-2 Emergency Release Kit for entry during power failure (store)
p
Wood for header, ceiling, and/or door braces (store)
p
Masonry fasteners for Safe-T-Beam® Bracket installation (store)
p
Safe-T-Beam® Bracket Extensions (dealer)
p
Masonry drill bit (store)
p
Extension Kit (for 8’ Garage Doors)(dealer)
Go to Assembly and Installation Poster for full
Installation Instructions.
Figure 8 Recommended Tools