Transferring Calls; Conference - NEC Univerge DT310 User Manual

TRANSFERRING CALLS

Using Manual Dial –
With a call in progress:
1. Press the Transfer key.
2. Dial the station number.
3. Announce the call (optional).
4. Replace the handset.
Using Direct Station Selection (DSS) –
With a call in progress:
1. Press the Transfer key.
2. Press the programmed DSS.
3. Announce the call (optional).
4. Replace the handset.
Note 1: If the called station is busy, replace the
handset to initiate a camp-on. Unanswered
camp-on calls and unscreened transfers will
recall to the transferring station.
To return to the original party, press the
Note 2:
flashing Line key or Conf key.
A Programmable Function Key may be
Note 3:
assigned for DSS.
To transfer a call directly to a personal voice
Note 4:
mailbox, dial 8 after dialing the station
number.
2-13 WED
HOLD
InPg

CONFERENCE

1. Establish an internal or external call.
2. Press CONF Softkey or the Conference key
3. Dial third party. If external, dial '0' for an outside
line.
4. When third party answers press ADD Softkey or
Conference Key
5. Press BEGIN Softkey or Conference key again.
6. A conference call is established.
Note: If you cannot add additional parties to your
conference, you have exceeded the system's
Conference limit.
7. Repeat steps 1~3 above to add more parties.
2-11 MON 10:56AM
TALKING TO
Conf
ICM DIAL
AnHd
28
5:40PM
STA 12345678
ExPg P/U
STA 12345
CONF
Dir