Dial Intercom; Conference; To Establish A Broker Call; Call Back (Station) - NEC UNIVERGE DT310 User Manual

Dial Intercom

To initiate
Lift handset or press the Speaker key.
Press DICM key.
Dial desired intercom station number (0-9). Tone
burst is sent. (Press 1 to change to ring tone signal.
To answer
DICM LED flashes, indicating an incoming intercom
call. Tone burst or ring tone is heard.
Press DICM.
Lift handset or press Speaker. LCD shows solid
green.

Conference

With call in progress, ask party to hold.
Press Transfer, receive interrupted dial tone.
Dial desired number.
After call is answered, press Conf key. Conf LED
lights.
Three-way conference is established.
CNF 2000
4:26 PM TUE 12 FEB 2008
If one party hangs up, other two remain connected.
Conf LED goes out.
2001
28

To Establish a Broker Call

While engaged in a call and wishing to consult a
third party, press Transfer. Caller is automatically
placed on hold.
Dial desired party to consult.
Press Transfer to return to original caller. Third
party is automatically placed on hold.
By repeating these steps, it is possible to alternate
between calls.
Note:
The display indicates connected station or trunk at
any given time.

Call Back (Station)

Lift handset or press Speaker.
Dial desired station number and receive busy tone
or ring back tone.
Press Call Back or dial access code and receive
service set tone.
Restore handset.
When busy station becomes idle or the station that
did not answer initiates or answers a call or
accesses a feature and then becomes idle, the
setting station is alerted by ring and flashing LED.