Garmin zumo 200 Quick Start Manual
Zumo 200 series
Hide thumbs
Also See for zumo 200:
- Owner's manual (58 pages) ,
- Quick start manual (13 pages) ,
- Installation instructions manual (46 pages)
Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for Garmin zumo 200
Summary of Contents for Garmin zumo 200
- Page 1 zūmo 200 series ® quick start manual for use with the zūmo 220...
- Page 2 GPS antenna Battery contacts Mini-USB connector under the weather cap Your zūmo Power button: Press and hold to turn on/off the zūmo. Press quickly to adjust the backlight brightness. Speaker Battery cover Serial number under the battery Release key: Slide up to open the battery cover. microSD card slot ™ under the battery zūmo 0 Quick Start Manual...
-
Page 3: Getting Started
Important Information Warning ‹ See the Important Safety and Product Information guide in the product box for product warnings and other important information. This product contains a lithium-ion battery. To prevent the possibility of personal injury or product damage caused by battery exposure to extreme heat, remove the device from the vehicle when exiting or store it out of direct sunlight. -
Page 4: Charging Your Zūmo
Connecting Power to the zūmo 1. Pull back the weather cap from the mini-USB connector located on the back of your zūmo. 2. Plug the vehicle power cable into the mini- USB connector. Charging Your zūmo Charge your zūmo for at least 4 hours before using on battery power. - Page 5 Mount Your zūmo on the Motorcycle Warning ‹ Incorrectly wiring the power cable with bare wire leads can result in damage to the vehicle or the battery and can cause bodily injury. Garmin strongly recommends having an experienced installer with the proper knowledge of electrical systems install the unit.
- Page 6 Washers Panhead screws Attach the Base Plate to the zūmo Mount 1. Thread the M4 × 40 mm panhead screws through the washers, cradle, spacers, and base plate. 2. Tighten the nuts to secure the base plate. Attach the Base Plate to the Handlebar Base 1.
-
Page 7: Configuring The Zūmo
Install Your zūmo in the Mount 1. Fit the bottom of your zūmo into the cradle. 2. Tilt the zūmo back into the cradle. 3. Press down the release lever. Release lever Cradle Remove Your zūmo from Either Mount 1. Press the release lever on the top of the mount to release the zūmo. -
Page 8: Using The Menu Page
Using the Menu Page ➊ ➋ ➌ ➏ ➐ ➑ ➊ GPS satellite strength. ➋ Bluetooth headset status. NOTE: Pages appear differently based on your usage mode and settings. ➌ Touch to change usage mode. ➍ Battery status. ➎ Current time. Touch to change time settings. -
Page 9: Using The Map Page
Using the Map Page Your route is marked with a magenta line. As you travel, your zūmo guides you to your destination with voice prompts, arrows on the map, and directions at the top of the map. A checkered flag marks your destination. If you depart from the original route, your zūmo recalculates the route and provides new directions. -
Page 10: Taking A Detour
Taking a Detour If the road ahead is closed, you can take a detour. NOTE: Detour is not available when navigating off road. 1. With a route active, touch Menu. 2. Touch Detour. The zūmo attempts to find an alternate route that avoids the current road or the next road on your turn list, and then returns to your original route. -
Page 11: Using Tracback
5. Touch on the zūmo. 6. Select your headset, and touch OK. 7. Enter the Bluetooth PIN for your headset, if necessary, and touch Done. 8. Touch OK. Using TracBack ® Touch Where To? > TracBack recent track. Touch Save to save the track to your Favorites. - Page 12 Garmin , the Garmin logo, zūmo , and TracBack ® ® countries. Garmin Lock is a trademark of Garmin Ltd. or its subsidiaries. These trademarks may not be used without the express ™ permission of Garmin. microSD is a trademark of the SD Card Association. Other trademarks and trade names are those of their ™...