Page 1
NZ: 0800 800 900 Hard Floor Cleaner Get Cleaning... What ’ s your Vax ’ s model number? What ’ s your serial number? (Located on the base of the machine) Note these down in case you need them in future. Please keep instructions for further use.
Page 3
Recovery tank lid and lter Carry handle Solution trigger Recovery tank Upper handle release button Mode selector Nozzle release buttons Cord hooks Clean solution tank cap Nozzle Handle release pedal Clean solution tank Squeegee Hard oor cleaning solution Clean solution tank release Bumper vax.com.au...
Page 4
Damage to the vacuum cleaner as a direct result of not adhering or vitreous materials. to the general safety instructions in this user guide invalidates Do not vacuum baking soda or any other powder-based carpet the warranty. refresher or deodoriser. Vax Service line: AU: 1300 361 505 NZ: 0800 800 900...
Step on pedal (A) to lower upright position until it upper handle release button handle to operating position. locks in place. and fold handle to storage Handle does not lock into a position. single position, but “ oats” to allow convenient operation. vax.com.au...
To wet clean with brushes turned ON, turn the dial to the WASH position. For wet pickup, turn the dial to the WET PICKUP position. Vax Service line: AU: 1300 361 505 NZ: 0800 800 900...
Page 7
Vax cleaning solution. IMPORTANT: Check for worn spots or joint separations before using, as these conditions could lead to damaged ooring when using water to clean oor.
IMPORTANT: Do not use the cleaner to pick up ammable or combustible liquids or chemicals. Do not use the cleaner to pick up detergents that contain solvent based ingredients. Vax Service line: AU: 1300 361 505 NZ: 0800 800 900...
4. to be cleaned. FIG. 5/1 Your Vax cleaner may be used to clean wood oors Overlap strokes by one inch to help prevent streaking. that have been sealed with a polyurethane coating and The cleaner’s suction will pick up the dirty solution can be cleaned with water.
As a general guide, Vax recommends lters are replaced every 3-6 months depending on the level of use to ensure optimum performance of your hard oor cleaner.
Maintenance (Keep your Vax as good as new) Cleaning the Nozzle Turn cleaner OFF and disconnect from electrical outlet. The cleaner’s nozzle can be removed for easy cleaning. FIG. 6/5 FIG. 6/6 FIG. 6/7 Slide the two nozzle release Remove nozzle by pulling Rinse nozzle under running water.
Maintenance (Keep your Vax as good as new) Cleaning the Brushes The brush assembly can be removed for easy cleaning. Turn cleaner OFF and disconnect from electrical outlet. Place handle in the upright position. Remove tanks to prevent leaking. Set aside.
Page 13
Ensure nozzle is replaced properly Nozzle not properly positioned and locked Excess cleaning solution foaming in tanks Use only Vax Floor Cleaner Water puddling behind cleaner Clean water tank not correctly installed Ensure tank is installed correctly Dirty water tank is full...
Page 14
8.30am to 5.00pm If you have queries or concerns about using your Vax, call the Vax Careline. Calls are charged at the standard local rate. Please make a note of the serial number and model number of the vacuum cleaner before calling.