Hardware Monitor Settings - D-Link NetDefend DFL-210 User Manual

13.17. Hardware Monitor Settings

13.17. Hardware Monitor Settings
HWM_PollInterval
Polling intervall for Hardware Monitor which is the delay in milliseconds between reading of
hardware monitor values. Minimum 100, Maximum 10000.
Default: 500 ms
HWMMem_Interval
Memory polling interval which is the delay in minutes between reading of memory values.
Minimum 1, Maximum 200.
Default: 15 mins
HWMMem_LogRepetition
Should we send a log message for each poll result that is in the Alert, Critical or Warning level, or
should we only send when a new level is reached. If True, a message is sent each time
HWMMem_Interval is triggered If False, a message is sent when a value goes from one level to
another.
Default: False
HWMMem_UsePercent
True if the memory monitor uses a percentage as the unit for monitoring, False if it uses Megabyte.
Applies to HWMMem_AlertLevel, HWMMem_CriticalLevel and HWMMem_WarningLevel.
Default: True
HWMMem_AlertLevel
Generate an Alert log message if free memory is below this value. Disable by setting to 0.
Maximum value is 10,000.
Default: 0
HWMMem_CriticalLevel
Generate a Critical log message if free memory is below this value. Disable by setting to 0.
Maximum value is 10,000.
Default: 0
HWMMem_WarningLevel
Generate a Warning log message if free memory is below this value. Disable by setting to 0.
Maximum value 10,000.
Default: 0
334
Chapter 13. Advanced Settings