Configuring A Radius Server - D-Link NetDefend DFL-210 User Manual

Network security firewall ver 2.26.01
Hide thumbs Also See for NetDefend DFL-210:
Table of Contents

Advertisement

8.2.7. HTTP Authentication
Destination Network lan_ip
3.
Click OK
B. Set up the Authentication Rule
1.
Go to User Authentication > User Authentication Rules > Add > User Authentication Rule
2.
Now enter:
Name: HTTPLogin
Agent: HTTP
Authentication Source: Local
Interface: lan
Originator IP: lannet
3.
For Local User DB choose lannet_auth_users
4.
For Login Type choose HTMLForm
5.
Click OK
C. Set up an IP rule to allow authenticated users to browse the Web.
1.
Go to Rules > IP Rules > Add> IP rule
2.
Now enter:
Name: Allow_http_auth
Action: NAT
Service: HTTP
Source Interface: lan
Source Network: lannet_users
Destination Interface any
Destination Network all-nets
3.
Click OK
Example 8.3. Configuring a RADIUS Server
The following steps illustrate how a RADIUS server is typically configured.
Web Interface
1.
User Authentication > External User Databases> Add > External User Database
2.
Now enter:
a.
Name: Enter a name for the server, for example ex-users
b.
Type: Select RADIUS
c.
IP Address: Enter the IP address of the server, or enter the symbolic name if the server has been
defined in the Address Book
d.
Port: 1812 (RADIUS service uses UDP port 1812 by default)
e.
Retry Timeout: 2 (NetDefendOS will resend the authentication request to the sever if there is no
response after the timeout, for example every 2 seconds. This will be retried a maximum of 3 times)
332
Chapter 8. User Authentication

Advertisement

Table of Contents
loading

Table of Contents