Server Switches Itself Off - Fujitsu PRIMERGY TX300 S7 Operating Manual

Troubleshooting and tips
8.2

Server switches itself off

Server Management has detected an error
Ê Check the error list of System Event Log in ServerView Operations Manager
or in the iRMC S3 web interface, and attempt to eliminate the error.
8.3 Screen remains blank
Monitor is switched off
Ê Switch on your monitor.
Screen has gone blank
Ê Press any key on the keyboard.
or
Ê Deactivate screen saver. Enter the appropriate password.
Brightness control is set to dark
Ê Set the brightness control on the monitor to light. For detailed information,
refer to the operating manual supplied with your monitor.
Power cable or monitor cable not connected
Ê Switch off the monitor and the server.
Ê Check whether the power cable is properly connected to the monitor and to
the grounded power outlet.
Ê Check whether the monitor cable is properly connected to the server and
monitor (if it is plugged in with a connector). If a separate graphics card is
installed in the server, then the monitor cable must be connected to the
graphics card.
Ê Switch on the monitor and the server.
86 Operating Manual
TX300 S7 / RX350 S7