Homelite UT10568 Getting Started Manual

WARNING: This Engine Starting Procedure is not a substitute for
reading the operator's manual. To reduce the risk of injury, user must
read and understand operator's manual before using this product.
50:1 Ratio = Mix 2.6 oz of 2-cycle engine lubricant (provided)
1
with 1 gallon of fresh gasoline in separate gas container.
1 GALLON
SHAKE. Pour into fuel tank.
GAS
BAR
2
OIL
Add bar lubricant to oil tank.
3
Set ignition switch to
RUN (I) position.
4
5
Press fully and release
PRIMER BULB 7 times.
x7
6
Pull CHOKE lever to the
FULL position.
7
Above 50 º F - Pull STARTER 3 times
Below 50 º F - Pull STARTER 5 times
8
Push choke lever to
RUN position.
Pull STARTER grip and rope until
9
engine runs.
Note: Allow the saw to run in this position
15-30 seconds, depending upon the temperature.
DEPRESS throttle release
10
then SQUEEZE and release throttle trigger.
988000564
3-9-12 (REV: 02)
Make The Most Of Your Purchase!
Go to www.homelite.com and register your new tool on-line.
For any questions about operating or maintaining your product, call the Homelite Help Line !
Your Product has been fully tested prior to shipment to ensure your complete satisfaction.
Troubleshooting tips are available in your operator's manual.
IMPORTANT: It is normal for chain saws to have bar and chain lubricant under the chassis after operating
the saw. This bar and chain lubricant is coming from the clutch cover area and is NOT an indication of a
leak. The clutch cover area must be saturated with lubricant to properly lubricate the bar and chain and
to ensure the long-term durability of your new chain saw.
HOW TO GET STARTED
®