Status And Alarm Menu - GE Digital Energy LP 11U Installation & User Manual

g

5.3.2 Status and Alarm Menu

The UPS alerts the user with a standard alarm screen that the operating mode has changed and/or that an
alarm situation occurs:
ON LINE
ALARM PRESS UP
Possible operating modes:
ON LINE
ON BYPASS
ON BATTERY
OUTPUT OFF
ON MANUAL BYPASS
on ECO-mode
Depressing the 'up' key from the standard alarm screen shows, in priority order, which alarms are active,. Scroll
through the screens with the 'up' and 'down' keys. Alarm message texts can succeed each other. The following
messages are possible:
LOADnotPROTECTED
CAP. C2 DEFECT
UPS OVERLOADED
REDUCE LOAD
UPS OVERLOADED
LOAD 143%
LOADnotPROTECTED
TEMP TOO HIGH
LOADnotPROTECTED
VOLTAGE TOO HIGH
BATTERY CHARGER
VOLTAGE TOO HIGH
BATTERY CHARGER
TEMP TOO HIGH
LX: OPM_LPU_11U_5K0_10K_1US_V030
The actual operating mode, the possible modes are mentioned below. The
lower line -if displayed- shows that an alarm occurred. More information can
be retrieved with the 'up' key. If no further information is available, the second
line is blank.
The normal operating mode. For more information see section 3.2.
Overload or failure situation. For more information see section 3.5.
For a detailed description of this mode see section 3.3.
No power is delivered to the load. This can be the result of a command via the
RS232 Port, or because no electric energy is available (utility failure, depleted
batteries).
Service mode. For more information see section 3.6.
ECO-Mode. See section 5.5.5
The output capacitor C2 is defective. Contact your dealer.
The load exceeds the rated output power of the UPS, and the output voltage
can no longer be guaranteed. This text alternates with the following screen:
showing the actual load as % of the nominal UPS rating. These messages are
displayed if the load is > 100%.
If the load exceeds 150% the UPS will immediately switch to bypass,
assuming that the conditions for a transfer to bypass are fulfilled. If an
overload condition between 100-150% persists, the UPS can eventually also
switch to bypass operation due to temperature protection. If a transfer to
bypass is inhibited (due to voltage or frequency errors of the utility supply) the
UPS may automatically switch off within a few seconds (load dependent).
Output power is lost at that moment. To avoid these problems, be absolutely
certain that the power demands of the protected equipment are within the
limits of the UPS.
The temperature of the heatsinks or output transformer is too high. As a result
the output voltage may be transferred to bypass.
The operating temperature can rise to intolerable levels as a result of:
extreme environmental temperature
lack of proper ventilation
an overload situation
fan failure
If the UPS operates in 'on line' mode, it will switch to bypass until the
temperature is normal again. If however the UPS operates 'on battery', a
shutdown will occur and output power is lost.
The internal DC voltage is too high, internal failure
The output voltage of the battery charger is too high, internal failure
The battery temperature is too high due to a battery failure or a too high
ambient temperature
Digital Energy
26
GE DE LP 11U UPS: Installation / User Manual 3.0 (US)
™
LP Series