Advertisement
Quick Links
OWNER'S MANUAL
Universal Large Cylinder Cart (042 934)
WARNING
ELECTRIC SHOCK can kill.
Do not touch live electrical parts.
Turn Off welding power source, and disconnect
input power.
Disconnect
deenergized supply BEFORE moving welding
power source.
CYLINDERS can explode if damaged.
Keep cylinders away from welding and other
electrical circuits.
Never touch cylinder with welding electrode.
Always secure cylinder to running gear, wall, or
other stationary support.
input
power
conductors
Figure 1. Assembled Universal Large Cylinder Cart
OM 685
August 2000
FALLING EQUIPMENT can cause injury
and damage.
Use proper equipment to lift unit.
If using lift forks, be sure lift forks extend out opposite
side of base.
from
Do not put any body part under unit while lifting.
159 756J
miscwarn1.1* 10/91
2000 MILLER Electric Mfg. Co.
Advertisement
Related Manuals for Miller Electric Universal Large Cylinder Cart
Summary of Contents for Miller Electric Universal Large Cylinder Cart
- Page 1 Keep cylinders away from welding and other electrical circuits. Never touch cylinder with welding electrode. Always secure cylinder to running gear, wall, or other stationary support. miscwarn1.1* 10/91 Figure 1. Assembled Universal Large Cylinder Cart 2000 MILLER Electric Mfg. Co.
- Page 2 601 872 Nut, 3/8-16 (2) 602 213 Washer, 3/8 lock (2) Be sure to provide Model when ordering replace- 7/16, 1/2, 9/16 in 010 954 Washer, 3/8 flat (2) ment parts. Figure 2. Universal Large Cylinder Cart Assembly OM-685 Page 2...
- Page 3 Bottom Tray XMT Welding Power Source Mounting Foot XMT 300 Power Source (F) Remove and discard mounting feet from base. Use installation location labeled F for XMT 300. Install using supplied 5/16 in screws. XMT 304, Dynsasty DX, Dynasty 300, Maxstar DX, Or Maxstar 300 Power Sources (G) Use installation location labeled G for these welding power sources.
- Page 4 60 Series Wire Feeder (B) Do not attempt to install a 60 series dual wire feeder on the universal large cylinder cart. Install wire feeders using supplied 10-24 x 5/8 screws, flat washers, lock washers, and stand-off.