Lenovo IdeaCentre Horizon 27 Series User Manual
Machine type: 10109/6266
Hide thumbs
Also See for IdeaCentre Horizon 27 Series:
- Manual (43 pages) ,
- Hardware maintenance manual (55 pages)
Related Manuals for Lenovo IdeaCentre Horizon 27 Series
Summary of Contents for Lenovo IdeaCentre Horizon 27 Series
-
Page 1: User Guide
Machine type: 10109/6266 Lenovo IdeaCentre Horizon 27 Series User Guide www.lenovo.com Version 1.0 2013.02 31503505... -
Page 2: Important Safety Information
Attention: Be aware of possible damage to programs, devices, or data. Note: Pay attention to this important information. © Copyright Lenovo 2013. All rights reserved. LIMITED AND RESTRICTED RIGHTS NOTICE: If data or software is delivered pursuant a General Services Administration “GSA” contract, use, reproduction, or... -
Page 4: Table Of Contents
Contents Important Safety Information Using the Computer Hardware ..........1 Front view of the computer .................2 Left and right view of the computer ............3 Rear view of the computer .................4 Computer stand ..................5 Connecting your computer .................5 Important information about using the computer ........6 Connecting to the Internet ................8 Using the E-Dice ................. - Page 5 Using the Rescue System ............25 OneKey Recovery ..................26 Driver and Application Installation .............27 Using the Software ..............29 Lenovo Support ..................30 Troubleshooting and Confirming Setup ......... 31 Troubleshooting Display Problems ............32 Troubleshooting Touch screen ..............33 Troubleshooting Audio Problems ..............33 Troubleshooting Software Problems ............34...
-
Page 6: Using The Computer Hardware
Using the Computer Hardware This chapter contains the following topics: Introduction to the computer hardware Ø Information on computer connections Ø Note: The descriptions in this chapter might be different from what you see on your computer, depending on the computer model and configuration. -
Page 7: Front View Of The Computer
Front view of the computer Built-in microphone Built-in camera Built-in microphone Hard disk drive indicator Bluetooth status indicator WIFI status indicator Battery status indicator Screen rotation button Touch button function On/Off (press and hold for 5 seconds) Mode switch button (PC mode/HDMI-in/Monitor Off) Brightness adjustment button Volume down Volume up... -
Page 8: Left And Right View Of The Computer
Left and right view of the computer Microphone connector Headphone connector Memory card reader USB connector USB connector HDMI-in connector Power connector Power button User Guide... -
Page 9: Rear View Of The Computer
Rear view of the computer Attention: Be careful not to block any air vents on the computer. Blocked air vents can cause overheating. Air vents Recesses Screw hole Note: The recesses and screw hole are designed for fixing the IdeaCentre Horizon 27 more firmly to a special desk. -
Page 10: Computer Stand
Computer stand Use the stand to position the display to your preference. It can be rotated between 15° and 90° from the vertical. Connecting your computer Note: Your computer may not have all of the connectors described in this section. Basic connector instructions Connector Description... -
Page 11: Important Information About Using The Computer
Connecting the power cord Important information about using the computer Press the power button on the side of the computer to turn on the computer. User Guide... - Page 12 Note: The buttons at the bottom of the screen are touch buttons. Touching them turns on the indicator lights. Hold the computer tightly when you carry it. User Guide...
-
Page 13: Connecting To The Internet
Connecting to the Internet To connect to the Internet, you’ll need a contract with an Internet Service Provider (ISP) and some hardware. IPSs and ISP offerings vary by country. Contact your ISP for offerings available in your country. Your computer is designed to support a wireless (selected models only) or wired network that connects your computer to other devices. -
Page 14: Using The E-Dice
Using the E-Dice This chapter contains the following topics: E-Dice instructons Ø Note: Only some models are equipped with E-Dice. Note: The interface and functionality of these features will depend on which software was shipped with the computer model you purchased. -
Page 15: E-Dice Components And Connectors
E-Dice Components and Connectors Battery indicator Charging connector Charging the E-Dice The E-Dice has an internal rechargeable battery. If the indicator light blinks while you are rolling the dice, this indicates the battery is low on power. To charge the battery, do the following: Put the E-Dice into the included USB power adapter and connect the adapter to the USB connector on your computer. -
Page 16: Playing With The E-Dice
You may need to manually pair the E-Dice if it does not work. To pair the E-Dice, do the following: 1. Open the Lenovo Tycoon game and go to the Dice Inspection interface. Click the Inspection Start button in the pop-up dialog box, then roll the E-Dice. The dice on the screen will roll and stop with the E-Dice. -
Page 17: Use And Maintenance
Use and Maintenance • The minimum age recommended for using the E-Dice is 14 years old. • Keep the E-Dice away from water or damp environments. Clean the dice with a soft dry cloth. • The effective range between the E-Dice and the computer is 2 meters. Find a comfortable posture when rolling the dice. -
Page 18: Using Windows 8
Using Windows 8 This chapter contains the following topics: Ø Switching between the main Windows 8 interfaces Ø The Charms Bar Ø Shutting down the computer Ø Switching between apps Ø Closing an app Ø Opening other system programs Ø Windows Help and Support Attention: The Windows 8 operating system is provided by Microsoft Corporation. -
Page 19: Switching Between The Main Windows 8 Interfaces
Switching between the main Windows 8 interfaces Windows 8 comes with two main user interfaces: the Start Screen and the Windows desktop. To switch from the Start Screen to the Windows desktop, do one of the following: • Select the Windows desktop tile on the Start Screen. •... -
Page 20: Switching Between Apps
Switching between apps Sometimes you want to get back to an app you were just using, or quickly switch through your recent apps. To switch between apps: Move the cursor to the top left corner, then click to bring in the next app. (If your computer is equipped with touch screen, swipe in from the left edge of the screen to bring in the next app.) Closing an app... - Page 21 User Guide...
-
Page 22: Touch Screen Instructions
Touch screen instructions This chapter contains the following topics: Touch Screen Calibration Ø User Gesture Instructions for the Touch screen Ø Attentions when using the Touch Screen Ø User Guide... -
Page 23: Touch Screen Calibration
The monitor is touch-sensitive thanks to its touch-sensitive screen. A touch screen is an input device just like a mouse or a keyboard, and the user’s fingers transmit position information via the touch screen to the computer. With this technology, you only need to touch the pictures or words on the computer display lightly with your finger, and the computer will react. -
Page 24: Basic Hand Gestures
Basic Hand Gestures 1. Single Click / Double Click For the item selected on the touch screen, with one finger touch it one or two times, to perform a single click or double click operation. This is similar to the action performed by clicking the mouse left button. - Page 25 3. Dragging Movement First touch your finger on the desired item on the screen and hold it there, then make a dragging movement. This is similar to the click and drag movement you can make with a mouse. 4. Rolling Movement When you move your finger one time vertically (or horizontally) on the touch screen, this is called a Rolling Operation.
- Page 26 5. Zoom Operation Touch two fingers lightly on the desired item on the touch screen, then keeping both fingers on the screen, change the distance between them. By increasing (or decreasing) the distance, you can perform a zoom in (or zoom out) operation.
-
Page 27: Related Touch Screen Settings
Related Touch Screen Settings • Select Hardware and Sound → Pen and Touch from the Settings charm. • Select touch actions which you wish to adjust. By clicking on “Settings”, you can adjust the “Speed” and “Spatial tolerance” parameters, to match the user’s natural way of double-clicking. -
Page 28: Precautions When Using The Touch Screen
Precautions when using the Touch Screen 1. When using the touch screen, be careful not to tear the surface with any sharp objects. 2. To ensure normal use of the touch screen, ensure that both the screen surface and your fingers are clean and dry. 3. - Page 29 7. The touch screen does not function in Rescue System mode. 8. The touch screen also does not function during the startup process, in Hibernate mode and in Sleep mode or Safe mode. User Guide...
-
Page 30: Using The Rescue System
Using the Rescue System This chapter contains the following topics: Ø OneKey Recovery Ø Driver and Application Installation Attention: Using OneKey Recovery will result in loss of data. • You can restore the C: drive of the computer to factory default settings or to the last system backup status using OneKey Recovery. -
Page 31: Onekey Recovery
Note: The recovery files and relevant data used by the rescue system are saved in the service partition. If the service partition is deleted or damaged by someone other than authorized Lenovo service personnel, Lenovo will not be liable for any losses arising therefrom in any way. -
Page 32: Driver And Application Installation
Driver and Application Installation The Driver and Application Installation function in the rescue system provides a way for the user to conveniently reinstall all of the Lenovo applications and drivers that were shipped with your Lenovo hardware. Method 1: Automatic Installation Repeatedly press and release the F2 key once turning on the computer until the Lenovo Rescue System opens, then select Drivers and Application Installation. - Page 33 User Guide...
-
Page 34: Using The Software
Using the Software This chapter contains the following topic: Ø Software instructions Note: The interface and functionality of these features will depend on which software was shipped with the computer model you purchased. User Guide... -
Page 35: Lenovo Support
Lenovo Support The Lenovo Support program enables you to register your computer with Lenovo, download and view user manuals for your computer, get the warranty information of your computer, and explore help and support information. To open this program, do the following: Click the Lenovo Support icon from the Start Screen or Search Screen. -
Page 36: Troubleshooting And Confirming Setup
Troubleshooting and Confirming Setup This chapter contains the following topic: Troubleshooting and Problem Resolution Ø User Guide... -
Page 37: Troubleshooting Display Problems
3. If the LCD screen has a LCD On/Off button, check that the LCD screen has been turned on. If still cannot solve the problem, contact Lenovo Customer Service. Problem: You need to change the display property settings. Setting display background and icon properties: 1. -
Page 38: Troubleshooting Touch Screen
2. Move any interfering devices away from the computer. 3. If the problem persists, contact Lenovo Service. Troubleshooting Touch screen Problem: The touch screen reacts, but not where you are touching it. -
Page 39: Troubleshooting Software Problems
Problem: No sound from headphones. Troubleshooting and problem resolution: • Check the headphone cable connection — ensure that the headphone cable is securely inserted into the headphone connector. • Adjust the Windows volume control — select the speaker icon from the Settings Charm or click the arrow on taskbar to show the hidden icons in Windows desktop mode, then click the speaker icon. -
Page 40: Troubleshooting Problems Hard Disks
Troubleshooting Problems Hard Disks Problem: The capacity of the hard disk, as indicated by the system, is less than the nominal capacity. Troubleshooting and problem resolution: For computers equipped with the OneKey Recovery feature, the system recovery feature needs to occupy some hard disk space. -
Page 41: Windows Help And Support
Windows Help and Support If you have a problem with the operating system, see the Windows Help and Support file. To open the Windows Help and Support file, do one of the following: • Select the Settings charm, then select Help. •... -
Page 42: Performing Daily Maintenance Tasks
Performing Daily Maintenance Tasks Cleaning the computer components Because many of the computer components consist of sophisticated integrated circuit boards, it is very important to periodically clean the computer to prevent dust buildup. The cleaning supplies you need to clean the components include: a vacuum cleaner, a soft cotton cloth, pure water (preferably purified or distilled water) and cotton swabs. - Page 43 User Guide...
-
Page 44: Appendix
Thank you for using Lenovo products. Carefully read all documents shipped with your computer before you install and use the product for the first time. Lenovo is not responsible for any loss except when caused by installation and operations performed by Lenovo professional service personnel. -
Page 45: Trademarks
Phenom, AMD Sempron, Catalyst, Cool ‘n’ Quiet, CrossFire, PowerPlay, Radeon, and The Ultimate Visual Experience are trademarks of Advanced Micro Devices, Inc. Other company, product, or service names referred to herein or in other Lenovo publications may be trademarks or service marks of others. All rights reserved. -
Page 46: Energy Star Statement
For more information about ENERGY STAR, go to: http://www.energystar.gov. Lenovo encourages you to make efficient use of energy an integral part of your day-to-day operations. To help in this endeavor, Lenovo has preset the following... -
Page 47: Enabling Erp Compliance Mode
Enabling ErP compliance mode You can enable the energy-related products directive (ErP) compliance mode through the Power menu in the Setup Utility program. This mode reduces electricity consumption when your computer is in standby mode or turned off. To enable ErP compliance mode in the Setup Utility program, do the following: 1.