CONTENTS Installation .....................3 DIN Front-Mount (Method A) ..................3 Installing the unit ....................3 Removing the unit .....................4 DIN Rear-Mount (Method B) ...................4 Using the Detachable Front Panel ................5 Wiring Connection ..................6 Operation .......................7 General Operation ....................7 Radio Operation......................8 CD Operation ......................9 Remote Control Operation..................10 Specification....................11 Trouble Shooting ..................12...
INSTALLATION Notes: DIN FRONT-MOUNT (Method A) • Choose the mounting location where Installing the unit the unit will not interfere with the normal driving function of the driver. • Before finally installing the unit, connect the wiring temporarily and make sure it is all connected up properly and the unit and the system work properly.
Removing the unit DIN REAR-MOUNT (Method B) Installation using the screw holes on the sides of the unit. (Open/Close) Fastening the unit to the factory radio mounting bracket. 1. Before removing the frame, press the 1. Select a position where the screw (OPEN/CLOSE) button to slide holes of the bracket and the screw down the front panel.
USING THE DETACHABLE FRONT PANEL To Detach the Front Panel To Reinstall the Front Panel 1. Press the (OPEN/CLOSE) button, 1. When the panel bracket is in slide the front panel will slide down. down position, insert the front panel into panel bracket and press (OPEN/CLOSE) button to slide up.
WIRING CONNECTION MAIN UNIT ANTENNA CONNECTOR (GREEN) SUBWOOFER CABLE IGNITION (BROWN) SWITCH (B+) Rch RED FRONT RCA CABLE YELLOW MEMORY CHOKE Lch WHITE BACK-UP BLACK (GREY) GROUND (B–) Rch RED REAR RCA CABLE BLUE POWER Lch WHITE ANTENNA WHITE GREY FRONT Lch FRONT Rch SPEAKER...
OPERATION Location and Function of Controls GENERAL OPERATION • FACEPLATE RELEASE • ON/OFF/ILLUMINATE Press (OPEN/CLOSE) button (7) to Switch on the unit by pressing any slide down the front panel and you button (except (open/close) button can press it again to slide the front (7) and EJECT button (24).
For Electrical Volume: • REMOTE SENSOR By pressing AUDIO ADJUST button Point the remote control handset to (11) or AUDIO ADJUST button (12), the remote sensor IR (23). it is possible to adjust the desired Press the function keys on the handset sound quality.
If both buttons have not pressed for CD OPERATION several seconds, they will retune to • SELECT TRACKS seek tuning mode and “AUTO” Press TUNE/SKIP/TRACK button appeared on the display. (16) or TUNE/SKIP/TRACK button • LOCAL/DISTANCE (17) to move to the previous track or Press LOC button (2) shortly to select the following track.
Remote Control Handset CONTROL & FUNCTION KEYS 1. POWER = Power ON/OFF Button 2. MOD = Mode Button 3. S = Select Button 4. DSP = Display Button 5. BND = Band Select Button 6. AMS = Automatically Memory Storing & Program Scanning Button 7.
SPECIFICATION GENERAL Power Supply Requirements : DC 12 Volts, Negative Ground Chassis Dimensions : 178 (W) x 155 (D) x 50 (H) Tone Controls : ± 10 dB - Bass (at 100 Hz) : ± 10 dB - Treble (at 10 KHz) Maximum Output Power : 4 x 60 Watts Current Drain...
The radio does The antenna cable is not Insert the antenna cable firmly. not work. The connected. radio station automatic The signals are too weak. Select a station manually. selection does not work. www.lanzar.com 88-C1151-18...