Plumbing; Connection To The Water Supply - Miele G 4281 Operating Instructions Manual

Plumbing

Connection to the water
supply
,
Installation, repairs and other
work by unqualified persons could
be dangerous.
,
Do not drink water from the
dishwasher!
– The dishwasher can heat its own
water to the temperature required by
the wash program. This allows for
connection of the machine to either a
hot (max. 140°F / 60°C) or cold water
source.
For lowest energy consumption and
fastest possible wash times connect
the dishwasher to a hot water
source. All programs use hot water in
the rinse cycles.
– The inlet hose is approximately 5 ft.
(1.5 m) long.
– The water inlet hose comes
equipped with an inlet hose ending
with a 3/8" female compression
fitting. This can be directly
connected to a water supply valve or
to an appropriate coupling.
If not connected directly to a water
supply valve, an appropriate
adapter (not included) is required.
54
– Water pressure: Must be between
4.5 - 145 psi (0.3 - 10 bar).
– If the water pressure if lower, a
"Water Intake" notification will be
shown. See "Frequently Asked
Questions" for more information.
– If the water pressure is higher than
shown, a pressure reducing valve
must be used.
Ensure that the water connection is
secure after the first use.
,
To prevent damage to the
dishwasher, it must only be
connected to a fully vented drainage
system.
,
Do not cut the intake hose. If the
hose is cut, the dishwasher will not
work. There will be a water leak. If
the hose is too long, coil it neatly
and place it behind or under the
machine.