Time Display; Standby - Miele G 4281 Operating Instructions Manual

Use

Time display

Before the program starts, the time
display shows the time of the selected
program in hours and minutes. The
remaining time is displayed during the
program.
The time that is displayed may vary for
the same program. It depends on the
temperature of the incoming water, the
reactivation cycle, the type of detergent
and the quantity and soiling of the
dishes.
When a program is selected for the first
time, the display shows an average
program time for cold water.
With every program, the electronics
correct the time according to the
temperature of the incoming water and
the size of the load.
28

Standby

A few minutes after the last button is
pressed or a few minutes after the end
of the program the dishwasher will
switch to Standby mode to save
energy. The time display and the
indicator lights are turned off and only
the K indicator light flashes slowly.
^ Press the K button if you want to turn
the indicator lights back on.
If the dishwasher is not turned off after
the program ends, after a few minutes
in standby mode it will turn off
completely (see Additional options -
Optimizing Standby).
If refill rinse aid or a fault is
displayed while a program is
running, the dishwasher will not
switch to Standby mode.
If you use a Tab detergent, you can
deactivate the refill messages and
let the dishwasher go into Standby
mode (see Before using for the first
time).
However, fault messages cannot be
turned off.