System Setup - Hardware; Introduction; Unpacking The System; Preparing For Setup - Bosch DIVAR DIP-6080-00N Quick Installation Manual

10 en | System setup - hardware
3

System setup - hardware

3.1

Introduction

Scope of delivery:
–
–
3.2

Unpacking the system

You should inspect the box the chassis was shipped in and note if it was damaged in any way.
If the chassis itself shows damage, file a damage claim with the carrier who delivered it and
notify the respective Bosch RMA desk.
You will also need it placed near at least one grounded power outlet.
Due to the weight of the system: After opening the top of the shipping box, one person should
stand at either end and lift the disk array out together.
Be sure to read the safety precautions.
3.3

Preparing for setup

The box the system is shipped in includes a rack mount kit, which you will need to install the
system into the rack.
Follow the steps in the order given to complete the installation process in a minimum amount
of time. Read this section before you begin the installation procedure outlined in the sections
that follow.
3.3.1

Choosing a setup location

–
–
–
–
Notice!
This product is not suitable for use with visual display work place devices acccording to §2 of
the the German Ordinance for Work with Visual Display Units.
3.3.2

Rack precautions

Warning!
To prevent bodily injury when mounting or servicing this unit in a rack, you must take special
!
precautions to ensure that the system remains stable. The following guidelines are provided
to ensure your safety:
2013.05 | V3 | DOC
DIVAR IP 6000 – 8-bay system, fully equipped with 8 hard drives (DIP‑6082‑8HD)
In addition to the system itself, the following items should have been shipped along with
each system
– One rackmount kit
– One AC power cable for each power supply in the system
– This quick install guide
Situate the system in a clean, dust-free area that is well ventilated. Avoid areas where
heat, electrical noise and electromagnetic fields are generated. Place the system near a
grounded power outlet.
Leave approximately 25 inches clearance in front of the rack to be able to open the front
door completely.
Leave approximately 30 inches of clearance in the back of the rack to allow for sufficient
airflow and ease in servicing.
Install the system only in a Restricted Access Location (dedicated equipment rooms,
service closets and the like).
Quick Installation Guide
DIVAR IP 6000 2U
Bosch Sicherheitssysteme GmbH