Autolamps; Instrument Lighting Dimmer; Headlamp Exit Delay - Ford 2013 Flex Owner's Manual

96
AUTOLAMPS (If equipped)
WARNING: In severe weather conditions, it may be necessary to
switch your headlamps on manually.
Note: If the vehicle is equipped with autolamps, it will have the
windshield wiper rainlamp feature. When the windshield wipers are
turned to low- or high-speed wiping during daylight, and the headlamp
control is in the autolamp position, the exterior lamps will turn on after a
brief delay and will remain on until the wipers are turned off.

INSTRUMENT LIGHTING DIMMER

• Press repeatedly or press and hold at the first position
until the desired level is reached.
• Fully press and hold the top of the control to activate
the "dome on" feature. This will turn on the interior
courtesy lights. Fully press and hold the bottom of the
control to turn off the interior courtesy lights.

HEADLAMP EXIT DELAY

You can set the delay time to keep the headlamps on for up to
three minutes after the ignition is turned off.
Follow the steps below to change the delay time (Steps 1 through 6
must be done within 10 seconds):
1. Turn the ignition off.
2. Turn the lighting control to the autolamp position.
2013 Flex (471)
Owners Guide gf, 4th Printing, December 2012
USA (fus)
Lighting
The autolamp system provides light
sensitive automatic on-off control
of the exterior lights normally
controlled by the headlamp control.
The headlamps will remain on for a
A
period of time after you switch the
ignition off. You can adjust the time
delay using the display controls in
the instrument cluster. See the
Information Displays chapter.