Ford 2013 Flex Owner's Manual page 239

238
Changing the Set Speed
There are three ways to change the set speed:
• Accelerate or brake to the desired speed and press SET upward and
release.
• Increase or decrease the speed by holding SET upward or downward
until the desired set speed is shown on the information display.
The vehicle speed will gradually change to the selected speed.
• Increase or decrease the speed in increments of 1 mph (2 km/h) by
briefly pressing SET upward or downward.
The system may apply the brakes to slow the vehicle down to the new
set speed. The set speed will display continuously in the information
display while the system is active.
Resuming the Set Speed
Note: Resume should only be used if you are aware of the set speed and
intend to return to it.
Press and release RES. The vehicle will return to the previously set
speed. The set speed will display continuously in the information display
while the system is active.
Low Speed Automatic Cancellation
The system is not functional at vehicle speeds below 16 mph (26 km/h).
An audible alarm sounds and the automatic braking released if the
vehicle drops below this speed.
Hilly Condition Usage
Note: An audible alarm sounds and the system shuts down if it is
applying brakes for an extended period of time. This allows the brakes to
cool down. The system will function normally again when the brakes
have cooled down.
You should select a lower gear position when the system is active in
situations such as prolonged downhill driving on steep grades, for
example driving in mountainous areas. Your vehicle needs additional
engine braking in these situations to reduce the load on the vehicle's
regular brake system to prevent them from overheating.
Switching Off Adaptive Cruise Control
Note: The set speed memory will erase when you switch the system off.
Press and release OFF or turn off the ignition.
2013 Flex (471)
Owners Guide gf, 4th Printing, December 2012
USA (fus)
Cruise Control