TURN SIGNAL/LIGHTS/HIGH BEAM LEVER
Turn Signal/Lane Change Assist
•
Tap the lever up or down once and the
turn signal (right or left) will flash briefly
to indicate a lane change and automati-
cally turn off.
Headlights/Parking Lights
•
The ignition switch must be in the ON/
RUN position for the headlights to operate.
•
Rotate the end of the lever to the first
detent for parking lights and headlight
operation.
High Beams
•
Pull the lever rearward to activate the high beams.
•
A high beam symbol will illuminate in the cluster to indicate the high beams are on.
NOTE:
For safe driving, turn off the high beams when oncoming traffic is present to prevent head-
light glare and as a courtesy to other motorists.
Flash To Pass
•
Pull the lever toward you to activate the high beams.The high beams will remain on until
the lever is released.
Headlight Delay (Follow Me Home)
•
Within two minutes of the ignition switch being turned to the OFF/LOCK position or
the ignition key being removed from the ignition, pull the turn signal lever toward the
steering wheel.
•
Each movement of the lever toward the steering wheel will increase the illumination
period by 30 seconds, up to a maximum of 210 seconds.
•
To deactivate, pull the multifunction lever toward the steering wheel and hold it for more
than two seconds.
NOTE:
Activation of Follow Me Home is only enabled once per key cycle and steps must be re-
peated each time you want to activate it.
Fog Lights
•
Push the fog light button, located on the center stack of the instrument panel just below
the radio, once to turn on the fog lights.
•
Push the button a second time to turn the fog lights off.
OPERATING YOUR VEHICLE
21