Reebok 1210 Elliptical Manual page 13

12. Apply grease to a Pedal Arm Axle (64).
Next, slide an M8 Washer (97) and an Axle
Spacer (77) onto an M8 x 13mm Screw (82), and
tighten the Screw a few turns into the Pedal Arm
Axle (64).
While a second person holds the front end of the
Right Pedal Arm (58) inside the bracket on the
Right Upper Body Leg (60), insert the Pedal Arm
Axle (64) into both parts.
Slide an M8 Washer (97) and an Axle Spacer
(77) onto another M8 x 13mm Screw (82), and
tighten the Screw a few turns into the Pedal Arm
Axle (64). Then, tighten both Screws at the
same time.
Repeat this step on the other side of the
elliptical.
See assembly step 5. Tighten the M10 x 25mm
Screws (99).
13. Orient the Shield Cover (75) assembly as shown.
Press the Shield Cover (75) onto the Left and
Right Shields (73, 74).
12
99
82
13
75
13
60
Grease
64
97
77
77
97
58
Avoid pinching
the wires
73, 74
82