Preinstallation Checklist - GBC Laminator Operation And Maintenance Manual

F-60 Operation and Maintenance Manual
6HFWLRQ  ,QVWDOODWLRQ
GBC Pro-Tech is committed to a program of ongoing
product improvement. As a result, we are providing
these instructions so that you can insure that your new
F-60 Laminator is properly and securely unpacked,
moved and installed.
Before a F-60 Laminator can be installed, there are a
few requirements that must be met. Make certain that
each of the requirements listed in the following prein-
stallation checklist are met before beginning installa-
tion.
Failure to follow the preinstallation checklist can
result in damage to the laminator.
3UHLQVWDOODWLRQ &KHFNOLVW
Are doorways and hallways wide enough for the
laminator to be moved to the installation site?
Is there ample room for the laminator?
A work area must be established that allows for
operation in both the front and the rear of the
machine and provides space for efficient material
flow. Figure 2-1 shows a typical machine area lay-
out.
Is the environment appropriate for the laminator?
The laminator requires a clean, dust and vapor free
environment to operate properly, such as an air
conditioned office area with forced 10% make up
air. However, the laminator must not be located
where there is air blowing directly on it. Major
fluctuation in temperature and humidity are to be
avoided.
The operating environment must be free of dust,
flammable liquids and vapors. You can be
injured by inhaling chemical vapors. Vapor build
up or stored flammable liquids can cause a fire.
Excessive dust can damage the laminator.
© GBC Pro-Tech 1998 July
CAUTION
WARNING
Do not locate the laminator where air is blowing
directly on the machine. The air flow can cool the
rolls unevenly and result in poor quality output.
Is there an appropriate power outlet available or
has a certified electrician been contacted to wire
the laminator directly?
The laminator requires 55A single phase, 220/230/
240 VAC service or, in Europe,
3 Phase, 240/400 VAC with 25 Amps per phase.
Do not attempt to defeat the grounding feature of
the ground plug on the laminator. You can be
severely shocked, electrocuted or cause a fire.
The three prong plug fits only into a grounding-
type power outlet. If you are unable to insert the
plug into the existing outlet, contact a qualified
electrician to replace the obsolete outlet.
Do not use an extension cord on this laminator.
You can be severely shocked, electrocuted or
cause a fire. If you need a longer cable contact a
qualified electrician.
Do not operate the laminator if the power cord is
damaged or frayed. You can be severely shocked,
electrocuted or cause a fire. Contact a qualified
electrician to replace the cord.
Do not allow anything to rest on the power cord.
Do not locate the cord where people can walk on
it. You or others can be severely shocked,
electrocuted or cause a fire.
Installation
CAUTION
WARNING
WARNING
WARNING
WARNING
2-1